Bogdan Costescu wrote:
> I now understood what the problem was, so I'll put it in words for 
> posterity: the Link Status bit of the MII Status register needs to be 
> read twice to first clear the error state (link bit=0) after which the 
> bit reports the actual value of the link. From the manual:

Yes, this is exactly the point.

> But I still don't agree with your solution: you are reading the Status 
> register twice in all cases, which is wrong. What you want is to read it 
> a second time only after the link was marked as down: a simple check if 
> bit 2 of the Status register is 0, in which case you issue the second 
> read. This still means that there will be 2 reads if the link remains 
> down, but at least there is only 1 read for the case where the link is 
> up and remains up.

I don't think this makes much of a difference in the big picture, but
you're certainly right: let's not waste more cycles than we have to.

Can we agree on the patch below?


-Tommy