Re: [irda-users] Is ircomm possible with smsc_ircc2?

["hinko.kocevar@cetrtapot.si" <hinko.kocevar@cetrtapot.si>]

Andrey Borzenkov wrote:
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
> 
> I have Toshiba Portege 4000, which apparently needs smsc_ircc2 driver. Driver 
> seems to load OK:
> 
> Detected unconfigured Toshiba laptop with ALi ISA bridge SMSC IrDA chip, 
> pre-configuring device.
> Activated ALi 1533 ISA bridge port 0x02e8.
> Activated ALi 1533 ISA bridge port 0x02f8.
> found SMC SuperIO Chip (devid=0x5a rev=00 base=0x002e): LPC47N227
> smsc_superio_flat(): IrDA not enabled
> smsc_superio_flat(): fir: 0x2f8, sir: 0x2e8, dma: 03, irq: 7, mode: 0x02
> SMsC IrDA Controller found
>  IrCC version 2.0, firport 0x2f8, sirport 0x2e8 dma=3, irq=7
> No transceiver found. Defaulting to Fast pin select
> 
> and it registers irda0 interface but no /dev/ircomm* ever appears. I need them 
> (or at least I /think/ I need them) for SynCE (for installing programs in my 
> Pocket LOOX).
> 
> What is missing? Do I need additional driver? How can I access ircomm on this 
> HW?

You probably need to load the ircomm-tty and ircomm modules on top of 
irda stack for /dev/ircomm*.

Best regards,
hinko

-- 
ČETRTA POT, d.o.o., Kranj
Planina 3
4000 Kranj
Slovenija
Tel. +386 (0) 4 280 66 37
E-mail: hinko.kocevar@cetrtapot.si
Http: www.cetrtapot.si