Hi,

with latest git I cannot use my intel 3945 wifi. It shows up in
ifconfig, but it just does not work.

dmesg output is:

iwl3945: Intel(R) PRO/Wireless 3945ABG/BG Network Connection driver for
Linux, 1.2.26ks
iwl3945: Copyright(c) 2003-2008 Intel Corporation
iwl3945 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
iwl3945 0000:03:00.0: setting latency timer to 64
iwl3945: Detected Intel Wireless WiFi Link 3945ABG
iwl3945: Tunable channels: 13 802.11bg, 23 802.11a channels
phy1: Selected rate control algorithm 'iwl-3945-rs'
iwl3945 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
iwl3945 0000:03:00.0: firmware: requesting iwlwifi-3945-1.ucode
Registered led device: iwl-phy1:radio
Registered led device: iwl-phy1:assoc
Registered led device: iwl-phy1:RX
Registered led device: iwl-phy1:TX
ADDRCONF(NETDEV_UP): wlan0: link is not ready
iwl3945: Microcode SW error detected.  Restarting 0x82000008.
iwl3945: Error Reply type 0x00000005 cmd REPLY_SCAN_CMD (0x80) seq
0x4416 ser 0x0000004B
iwl3945: Can't stop Rx DMA.
Registered led device: iwl-phy1:radio
Registered led device: iwl-phy1:assoc
Registered led device: iwl-phy1:RX
Registered led device: iwl-phy1:TX


with 2.6.27 it works perfectly.

.config is attached

Which additional info should I provide?

cu
Dieter