Re: [IR-RFC PATCH v4 0/6] In-kernel IR support using evdev

[Stefan Richter <stefanr@s5r6.in-berlin.de>]

Jarod Wilson wrote:
> On 11/26/2009 08:34 PM, Jon Smirl wrote:
>> Raw mode. There are three sysfs attributes - ir_raw, ir_carrier,
>> ir_xmitter. Read from ir_raw to get the raw timing data from the IR
>> device. Set carrier and active xmitters and then copy raw data to
>> ir_raw to send. These attributes may be better on a debug switch. You
>> would use raw mode when decoding a new protocol. After you figure out
>> the new protocol, write an in-kernel encoder/decoder for it.
> 
> Also neglected to recall there was raw IR data access too. However, a
> few things... One, this is, in some sense, cheating, as its not an input
> layer interface being used. :) Granted though, it *is* an existing
> kernel interface being used, instead of adding a new one. Two, there's
> no userspace to do anything with it at this time.

No; it is a new interface, just using an existing mechanism (sysfs). Not
all of sysfs in itself is an interface really; rather there is a number
of interfaces which are implemented by means of sysfs.

sysfs is primarily meant for simple textual attributes though, not for
I/O streams.
-- 
Stefan Richter
-=====-==--= =-== ==-==
http://arcgraph.de/sr/