Konrad Rzeszutek Wilk a écrit : > On Fri, Jan 21, 2011 at 10:41:54PM +0100, matthieu castet wrote: >> Konrad Rzeszutek Wilk a écrit : >>>> - * .data and .bss should always be writable. >>>> + * .data and .bss should always be writable, but xen won't like >>>> + * if we make page table rw (that live in .data or .bss) >>>> */ >>>> +#ifdef CONFIG_X86_32 >>>> if (within(address, (unsigned long)_sdata, (unsigned long)_edata) || >>>> - within(address, (unsigned long)__bss_start, (unsigned long)__bss_stop)) >>>> - pgprot_val(required) |= _PAGE_RW; >>>> + within(address, (unsigned long)__bss_start, (unsigned long)__bss_stop)) { >>>> + unsigned int level; >>>> + if (lookup_address(address, &level) && (level != PG_LEVEL_4K)) >>>> + pgprot_val(forbidden) |= _PAGE_RW; >>>> + } >>>> +#endif >>>> #if defined(CONFIG_X86_64) && defined(CONFIG_DEBUG_RODATA) >>>> >>>> fyi, it does make it boot. >>> Hold it.. ccache is a wonderful tool but I think I've just "rebuilt" the >>> binaries with the .bss HPAGE_ALIGN aligment by mistake, so this path got never >>> taken. >>> >>> >> Ok, >> >> ATM I saw the following solution to solve the problem : >> 1) remove the data/bss check in static_protections, it was introduced by NX patches (64edc8ed). But I am not sure it >> is really needed anymore. >> 2) add ". = ALIGN(HPAGE_SIZE)" somewhere after init section. But if we want not to be allocated in image we >> should put it before bss. And if we want to be freed after init, we should put before .init.end. >> This mean moving .smp_locks (and .data_nosave when x86 will be added) before init section. I have no idea of the impact. >> 3) add some logic in arch/x86/xen/mmu.c, that will ignore RW page setting for the page table marked RO. >> 4) make static_protections take and old_prot argument, and only apply RW .data/.bss requirement if page is already RW. >> >> If possible I will go for 1). > > Sounds good. Just send me the patch and I will test it. Ok, what give you the attached patch. I don't know if I should give the printk or not. Matthieu