Re: Aquantia PHY in OCSGMII mode?

[Andrew Lunn <andrew@lunn.ch>]

On Thu, Jul 31, 2025 at 04:59:09PM +0200, Alexander Wilhelm wrote:
> Hello devs,
> 
> I'm fairly new to Ethernet PHY drivers and would appreciate your help. I'm
> working with the Aquantia AQR115 PHY. The existing driver already supports the
> AQR115C, so I reused that code for the AQR115, assuming minimal differences. My
> goal is to enable 2.5G link speed. The PHY supports OCSGMII mode, which seems to
> be non-standard.
> 
> * Is it possible to use this mode with the current driver?
> * If yes, what would be the correct DTS entry?
> * If not, I’d be willing to implement support. Could you suggest a good starting point?

If the media is using 2500BaseT, the host side generally needs to be
using 2500BaseX. There is code which mangles OCSGMII into
2500BaseX. You will need that for AQC115.

You also need a MAC driver which says it supports 2500BaseX.  There is
signalling between the PHY and the MAC about how the host interface
should be configured, either SGMII for <= 1G and 2500BaseX for
2.5G.

Just watch out for the hardware being broken, e.g:

static int aqr105_get_features(struct phy_device *phydev)
{
        int ret;

        /* Normal feature discovery */
        ret = genphy_c45_pma_read_abilities(phydev);
        if (ret)
                return ret;

        /* The AQR105 PHY misses to indicate the 2.5G and 5G modes, so add them
         * here
         */
        linkmode_set_bit(ETHTOOL_LINK_MODE_5000baseT_Full_BIT,
                         phydev->supported);
        linkmode_set_bit(ETHTOOL_LINK_MODE_2500baseT_Full_BIT,
                         phydev->supported);

The AQR115 might support 2.5G, but does it actually announce it
supports 2.5G?

	 Andrew