Re: [PATCH] firmware: arm_scmi: Use dev_err_probe() simplify the code

[Dan Carpenter <dan.carpenter@linaro.org>]

On Thu, May 15, 2025 at 02:59:24PM +0100, Cristian Marussi wrote:
> On Thu, May 15, 2025 at 08:38:55PM +0800, long.yunjian@zte.com.cn wrote:
> > From: Yumeng Fang <fang.yumeng@zte.com.cn>
> > 
> 
> Hi,
> 
> > In the probe path, dev_err() can be replaced with dev_err_probe()
> > which will check if error code is -EPROBE_DEFER and prints the
> > error name. It also sets the defer probe reason which can be
> > checked later through debugfs.
> 
> All true...but...if you look at the main scmi_probe() function all of these
> failures are trapped at that level currently on the return path...
> 
> see the call chain from
> 
> scmi_probe()
> 	....
> 	ret = scmi_channels_setup(info); 
> 	...
> 
> ...so your probe errors will be overridden there with a more generic message
> left in debugfs at the top level.

Good point.  But that feels like a mistake in dev_err_probe().
Ideally, it would print the first error message.  I bet someone
will eventually fix this.

regards,
dan carpenter