Re: [PATCH v2 4/5] iio: pressure: bmp280: Add support for BMP380 sensor family

[Angel Iglesias <ang.iglesiasg@gmail.com>]

On lun, 2022-07-04 at 07:52 +0300, Dan Carpenter wrote:
> On Mon, Jul 04, 2022 at 02:32:09AM +0200, Angel Iglesias wrote:
> > +/* Send a command to BMP3XX sensors */
> > +static int bmp380_cmd(struct bmp280_data *data, u8 cmd)
> > +{
> > +       int ret;
> > +       unsigned int reg;
> > +
> > +       /* check if device is ready to process a command */
> > +       ret = regmap_read(data->regmap, BMP380_REG_STATUS, &reg);
> > +       if (ret) {
> > +               dev_err(data->dev, "failed to read error
> > register\n");
> > +               return ret;
> > +       }
> > +       if (!(cmd & BMP380_STATUS_CMD_RDY_MASK)) {
> 
> This looks like it should be "reg" instead of command?

Yes, it should. Thanks for the catch!

> > +               dev_err(data->dev, "device is not ready to accept
> > commands\n");
> > +               return -EBUSY;
> > +       }
> > +
> > +       /* send command to process */
> > +       ret = regmap_write(data->regmap, BMP380_REG_CMD, cmd);
> > +       if (ret) {
> > +               dev_err(data->dev, "failed to send command to
> > device\n");
> > +               return ret;
> > +       }
> > +       /* wait for 2ms for command to be proccessed */
> > +       usleep_range(data->start_up_time, data->start_up_time +
> > 100);
> > +       /* check for command processing error */
> > +       ret = regmap_read(data->regmap, BMP380_REG_ERROR, &reg);
> > +       if (ret) {
> > +               dev_err(data->dev, "error reading ERROR reg\n");
> > +               return ret;
> > +       }
> > +       if (reg & BMP380_ERR_CMD_MASK) {
> > +               dev_err(data->dev, "error processing command
> > 0x%X\n", cmd);
> > +               return -EINVAL;
> > +       }
> > +       dev_dbg(data->dev, "Command 0x%X proccessed
> > successfully\n", cmd);
> > +
> > +       return 0;
> > +}
> 
> regards,
> dan carpenter