Re: [PATCH net-next 1/2] net: phy: micrel: lan8814 led errata

[Wojciech Drewek <wojciech.drewek@intel.com>]

On 28.02.2024 07:28, Horatiu Vultur wrote:
> Lan8814 phy led behavior is not correct. It was noticed that the led
> still remains ON when the cable is unplugged while there was traffic
> passing at that time.
> 
> The fix consists in clearing bit 10 of register 0x38, in this way the
> led behaviour is correct and gets OFF when there is no link.
> 
> Signed-off-by: Horatiu Vultur <horatiu.vultur@microchip.com>
> ---
>  drivers/net/phy/micrel.c | 17 +++++++++++++++++
>  1 file changed, 17 insertions(+)
> 
> diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
> index 9b69735819896..5a0cc89eaebdd 100644
> --- a/drivers/net/phy/micrel.c
> +++ b/drivers/net/phy/micrel.c
> @@ -114,6 +114,9 @@
>  #define LAN8814_INTR_CTRL_REG_POLARITY		BIT(1)
>  #define LAN8814_INTR_CTRL_REG_INTR_ENABLE	BIT(0)
>  
> +#define LAN8814_EEE_STATE			0x38
> +#define LAN8814_EEE_STATE_MASK2P5P		BIT(10)
> +
>  /* Represents 1ppm adjustment in 2^32 format with
>   * each nsec contains 4 clock cycles.
>   * The value is calculated as following: (1/1000000)/((2^-32)/4)
> @@ -3288,6 +3291,19 @@ static int lan8814_release_coma_mode(struct phy_device *phydev)
>  	return 0;
>  }
>  
> +static void lan8814_errata_fixes(struct phy_device *phydev)

This name is too generic IMO.
Maybe: lan8814_clear_2psp_bit

> +{
> +	u16 val;
> +
> +	/* It was noticed that when traffic is passing through the PHY and the
> +	 * cable is removed then the LED was still one even though there is no
> +	 * link
> +	 */
> +	val = lanphy_read_page_reg(phydev, 2, LAN8814_EEE_STATE);
> +	val &= ~LAN8814_EEE_STATE_MASK2P5P;
> +	lanphy_write_page_reg(phydev, 2, LAN8814_EEE_STATE, val);
> +}
> +
>  static int lan8814_probe(struct phy_device *phydev)
>  {
>  	const struct kszphy_type *type = phydev->drv->driver_data;
> @@ -3323,6 +3339,7 @@ static int lan8814_probe(struct phy_device *phydev)
>  	}
>  
>  	lan8814_ptp_init(phydev);
> +	lan8814_errata_fixes(phydev);
>  
>  	return 0;
>  }