Re: [RFC 01/23] gpio/omap: raw read and write endian fix

[Javier Martinez Canillas <javier.martinez@collabora.co.uk>]

On 11/19/2013 10:29 AM, Linus Walleij wrote:
> On Sat, Nov 16, 2013 at 1:01 AM, Taras Kondratiuk
> <taras.kondratiuk@linaro.org> wrote:
> 
>> From: Victor Kamensky <victor.kamensky@linaro.org>
>>
>> All OMAP IP blocks expect LE data, but CPU may operate in BE mode.
>> Need to use endian neutral functions to read/write h/w registers.
>> I.e instead of __raw_read[lw] and __raw_write[lw] functions code
>> need to use read[lw]_relaxed and write[lw]_relaxed functions.
>> If the first simply reads/writes register, the second will byteswap
>> it if host operates in BE mode.
>>
>> Changes are trivial sed like replacement of __raw_xxx functions
>> with xxx_relaxed variant.
>>
>> Signed-off-by: Victor Kamensky <victor.kamensky@linaro.org>
>> Signed-off-by: Taras Kondratiuk <taras.kondratiuk@linaro.org>
> 
> Since I generally just dislike __raw accessors I went and applied
> this. If it collides with any of Tony's fixup work I might need to
> take the patch out again, no big deal.
> 
> Some ACKs would be nice, but unless there are major objections
> this stays merged.

Looks good to me and also I've tested this patch on a TI DM3730 (Cortex A-8)
board in LE mode and found no regressions on devices using a GPIO.

Tested-by: Javier Martinez Canillas <javier.martinez@collabora.co.uk>

> 
> Yours,
> Linus Walleij
> 

Thanks a lot and best regards,
Javier