Re: [LINUX PATCH v12 1/2] dt-bindings: memory: Add pl353 smc controller devicetree binding information

[Michal Simek <michal.simek@xilinx.com>]

On 29. 11. 18 13:57, Naga Sureshkumar Relli wrote:
> Add pl353 static memory controller devicetree binding information.
> 
> Signed-off-by: Naga Sureshkumar Relli <naga.sureshkumar.relli@xilinx.com>
> Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
> ---
>  .../bindings/memory-controllers/pl353-smc.txt      | 47 ++++++++++++++++++++++
>  1 file changed, 47 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/memory-controllers/pl353-smc.txt
> 
> diff --git a/Documentation/devicetree/bindings/memory-controllers/pl353-smc.txt b/Documentation/devicetree/bindings/memory-controllers/pl353-smc.txt
> new file mode 100644
> index 0000000..d56615f
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/memory-controllers/pl353-smc.txt
> @@ -0,0 +1,47 @@
> +Device tree bindings for ARM PL353 static memory controller
> +
> +PL353 static memory controller supports two kinds of memory
> +interfaces.i.e NAND and SRAM/NOR interfaces.
> +The actual devices are instantiated from the child nodes of pl353 smc node.
> +
> +Required properties:
> +- compatible		: Should be "arm,pl353-smc-r2p1", "arm,primecell".
> +- reg			: Controller registers map and length.
> +- clock-names		: List of input clock names - "memclk", "apb_pclk"
> +			  (See clock bindings for details).
> +- clocks		: Clock phandles (see clock bindings for details).
> +- address-cells		: Must be 2.
> +- size-cells		: Must be 1.
> +
> +Child nodes:
> + For NAND the "arm,pl353-nand-r2p1" and for NOR the "cfi-flash" drivers are
> +supported as child nodes.
> +
> +for NAND partition information please refer the below file
> +Documentation/devicetree/bindings/mtd/partition.txt
> +
> +Example:
> +	smcc: memory-controller@e000e000
> +			compatible = "arm,pl353-smc-r2p1", "arm,primecell";
> +			clock-names = "memclk", "apb_pclk";
> +			clocks = <&clkc 11>, <&clkc 44>;
> +			reg = <0xe000e000 0x1000>;
> +			#address-cells = <2>;
> +			#size-cells = <1>;
> +			ranges = <0x0 0x0 0xe1000000 0x1000000 //Nand CS Region
> +				  0x1 0x0 0xe2000000 0x2000000 //SRAM/NOR CS Region
> +				  0x2 0x0 0xe4000000 0x2000000>; //SRAM/NOR CS Region
> +			nand_0: flash@e1000000 {
> +				compatible = "arm,pl353-nand-r2p1"
> +				reg = <0 0 0x1000000>;
> +				(...)
> +			};
> +			nor0: flash@e2000000 {
> +				compatible = "cfi-flash";
> +				reg = <1 0 0x2000000>;
> +			};
> +			nor1: flash@e4000000 {
> +				compatible = "cfi-flash";
> +				reg = <2 0 0x2000000>;
> +			};
> +	};
> 

v11 was sent long time ago and also reviewed by Linus here
https://lore.kernel.org/patchwork/patch/961603/

I can't see changelog which you have in v11. And also recorded changes
if any.
Then this driver will go through arm-soc tree via me.

Thanks,
Michal