From: <Tudor.Ambarus@microchip.com>
To: <p.yadav@ti.com>, <miquel.raynal@bootlin.com>, <richard@nod.at>,
<vigneshr@ti.com>, <linux-mtd@lists.infradead.org>,
<linux-kernel@vger.kernel.org>
Cc: <nsekhar@ti.com>, <boris.brezillon@collabora.com>
Subject: Re: [PATCH v14 01/15] mtd: spi-nor: core: use EOPNOTSUPP instead of ENOTSUPP
Date: Thu, 1 Oct 2020 07:19:14 +0000 [thread overview]
Message-ID: <5340adf5-1bb2-1eff-3812-6976b3b76faf@microchip.com> (raw)
In-Reply-To: <20200930185732.6201-2-p.yadav@ti.com>
On 9/30/20 9:57 PM, Pratyush Yadav wrote:
> EXTERNAL EMAIL: Do not click links or open attachments unless you know the content is safe
>
> ENOTSUPP is not a SUSV4 error code. Using EOPNOTSUPP is preferred
> in its stead.
>
> Reviewed-by: Tudor Ambarus <tudor.ambarus@microchip.com>
The R-b tag should be after your S-o-b. This applies to other
patches in the series too. No need to resubmit, it can be fixed when
applying.
> Signed-off-by: Pratyush Yadav <p.yadav@ti.com>
> ---
> drivers/mtd/spi-nor/core.c | 10 +++++-----
> 1 file changed, 5 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
> index 0369d98b2d12..4d0f8d165544 100644
> --- a/drivers/mtd/spi-nor/core.c
> +++ b/drivers/mtd/spi-nor/core.c
> @@ -2281,7 +2281,7 @@ static int spi_nor_hwcaps_pp2cmd(u32 hwcaps)
> *@nor: pointer to a 'struct spi_nor'
> *@op: pointer to op template to be checked
> *
> - * Returns 0 if operation is supported, -ENOTSUPP otherwise.
> + * Returns 0 if operation is supported, -EOPNOTSUPP otherwise.
> */
> static int spi_nor_spimem_check_op(struct spi_nor *nor,
> struct spi_mem_op *op)
> @@ -2295,12 +2295,12 @@ static int spi_nor_spimem_check_op(struct spi_nor *nor,
> op->addr.nbytes = 4;
> if (!spi_mem_supports_op(nor->spimem, op)) {
> if (nor->mtd.size > SZ_16M)
> - return -ENOTSUPP;
> + return -EOPNOTSUPP;
>
> /* If flash size <= 16MB, 3 address bytes are sufficient */
> op->addr.nbytes = 3;
> if (!spi_mem_supports_op(nor->spimem, op))
> - return -ENOTSUPP;
> + return -EOPNOTSUPP;
> }
>
> return 0;
> @@ -2312,7 +2312,7 @@ static int spi_nor_spimem_check_op(struct spi_nor *nor,
> *@nor: pointer to a 'struct spi_nor'
> *@read: pointer to op template to be checked
> *
> - * Returns 0 if operation is supported, -ENOTSUPP otherwise.
> + * Returns 0 if operation is supported, -EOPNOTSUPP otherwise.
> */
> static int spi_nor_spimem_check_readop(struct spi_nor *nor,
> const struct spi_nor_read_command *read)
> @@ -2338,7 +2338,7 @@ static int spi_nor_spimem_check_readop(struct spi_nor *nor,
> *@nor: pointer to a 'struct spi_nor'
> *@pp: pointer to op template to be checked
> *
> - * Returns 0 if operation is supported, -ENOTSUPP otherwise.
> + * Returns 0 if operation is supported, -EOPNOTSUPP otherwise.
> */
> static int spi_nor_spimem_check_pp(struct spi_nor *nor,
> const struct spi_nor_pp_command *pp)
> --
> 2.28.0
>
next prev parent reply other threads:[~2020-10-01 7:19 UTC|newest]
Thread overview: 40+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-09-30 18:57 [PATCH v14 00/15] mtd: spi-nor: add xSPI Octal DTR support Pratyush Yadav
2020-09-30 18:57 ` [PATCH v14 01/15] mtd: spi-nor: core: use EOPNOTSUPP instead of ENOTSUPP Pratyush Yadav
2020-10-01 7:19 ` Tudor.Ambarus [this message]
2020-10-01 7:34 ` Pratyush Yadav
2020-10-01 7:50 ` Miquel Raynal
2020-10-01 8:18 ` Tudor.Ambarus
2020-10-01 10:50 ` Vignesh Raghavendra
2020-09-30 18:57 ` [PATCH v14 02/15] mtd: spi-nor: add spi_nor_controller_ops_{read_reg,write_reg,erase}() Pratyush Yadav
2020-10-01 7:21 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 03/15] mtd: spi-nor: add support for DTR protocol Pratyush Yadav
2020-10-01 7:46 ` Tudor.Ambarus
2020-10-01 8:37 ` Pratyush Yadav
2020-10-01 8:49 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 04/15] mtd: spi-nor: sfdp: get command opcode extension type from BFPT Pratyush Yadav
2020-09-30 18:57 ` [PATCH v14 05/15] mtd: spi-nor: sfdp: parse xSPI Profile 1.0 table Pratyush Yadav
2020-10-01 7:49 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 06/15] mtd: spi-nor: core: use dummy cycle and address width info from SFDP Pratyush Yadav
2020-10-01 7:50 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 07/15] mtd: spi-nor: core: do 2 byte reads for SR and FSR in DTR mode Pratyush Yadav
2020-10-01 7:52 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 08/15] mtd: spi-nor: core: enable octal DTR mode when possible Pratyush Yadav
2020-10-01 8:09 ` Tudor.Ambarus
2020-10-01 8:42 ` Pratyush Yadav
2020-09-30 18:57 ` [PATCH v14 09/15] mtd: spi-nor: Introduce SNOR_F_IO_MODE_EN_VOLATILE Pratyush Yadav
2020-09-30 18:57 ` [PATCH v14 10/15] mtd: spi-nor: Parse SFDP SCCR Map Pratyush Yadav
2020-10-01 8:20 ` Tudor.Ambarus
2020-10-01 11:56 ` Pratyush Yadav
2020-09-30 18:57 ` [PATCH v14 11/15] mtd: spi-nor: sfdp: detect Soft Reset sequence support from BFPT Pratyush Yadav
2020-10-01 8:21 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 12/15] mtd: spi-nor: core: perform a Soft Reset on shutdown Pratyush Yadav
2020-10-01 8:23 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 13/15] mtd: spi-nor: core: disable Octal DTR mode on suspend Pratyush Yadav
2020-10-01 8:26 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 14/15] mtd: spi-nor: spansion: add support for Cypress Semper flash Pratyush Yadav
2020-10-01 8:35 ` Tudor.Ambarus
2020-10-01 8:40 ` Pratyush Yadav
2020-10-01 8:50 ` Tudor.Ambarus
2020-09-30 18:57 ` [PATCH v14 15/15] mtd: spi-nor: micron-st: allow using MT35XU512ABA in Octal DTR mode Pratyush Yadav
2020-10-01 8:38 ` Tudor.Ambarus
2020-10-01 19:43 ` Pratyush Yadav
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=5340adf5-1bb2-1eff-3812-6976b3b76faf@microchip.com \
--to=tudor.ambarus@microchip.com \
--cc=boris.brezillon@collabora.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=miquel.raynal@bootlin.com \
--cc=nsekhar@ti.com \
--cc=p.yadav@ti.com \
--cc=richard@nod.at \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®