Re: [PATCH v5] ARM: boot: Obtain start of physical memory from DTB

[Dmitry Osipenko <digetx@gmail.com>]

21.04.2020 18:19, Ard Biesheuvel пишет:
> On Wed, 15 Apr 2020 at 17:34, Geert Uytterhoeven
> <geert+renesas@glider.be> wrote:
>>
>> Currently, the start address of physical memory is obtained by masking
>> the program counter with a fixed mask of 0xf8000000.  This mask value
>> was chosen as a balance between the requirements of different platforms.
>> However, this does require that the start address of physical memory is
>> a multiple of 128 MiB, precluding booting Linux on platforms where this
>> requirement is not fulfilled.
>>
>> Fix this limitation by obtaining the start address from the DTB instead,
>> if available (either explicitly passed, or appended to the kernel).
>> Fall back to the traditional method when needed.
>>
>> This allows to boot Linux on r7s9210/rza2mevb using the 64 MiB of SDRAM
>> on the RZA2MEVB sub board, which is located at 0x0C000000 (CS3 space),
>> i.e. not at a multiple of 128 MiB.
>>
>> Suggested-by: Nicolas Pitre <nico@fluxnic.net>
>> Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
>> Reviewed-by: Nicolas Pitre <nico@fluxnic.net>
>> Reviewed-by: Ard Biesheuvel <ardb@kernel.org>
>> Tested-by: Marek Szyprowski <m.szyprowski@samsung.com>
>> Tested-by: Dmitry Osipenko <digetx@gmail.com>
> 
> This is ready to go into the patch system, no?
> 
> The sooner Russell picks it up, the sooner I can respin my patches
> that go on top.
> 
> Thanks,

The v5 works for me on NVIDIA Tegra, just in case.