Re: [PATCH 0/9] Add STiH407 fanmily pinctrl DT for tsin, tsout and mtsin channels

[Maxime Coquelin <maxime.coquelin@st.com>]

Hi Peter,

On 06/10/2015 04:03 PM, Peter Griffin wrote:
> Hi folks,
>
> This set adds in the necessary DT pinctrl configuration for the transport stream
> input channels, transport stream output channels and merged transport stream input
> channels for STiH407 family silicon.
>
> Some of these channels have alternate pinctrl configurations depending on the board
> design. These pinctrl groups will be used by the LinuxDVB c8sectpfe driver which
> will be upstreamed in due course, which allows LDVB tuners and demodulators to be
> used with an upstream kernel to get transport stream data into the SoC.
>
> regards,
>
> Peter.
>
> Peter Griffin (9):
>    ARM: STi: DT: Add STiH407 family tsin0 pinctrl configuration
>    ARM: STi: DT: Add STiH407 family tsin1 pinctrl configuration
>    ARM: STi: DT: Add STiH407 family tsin2 pinctrl configuration
>    ARM: STi: DT: Add STiH407 family tsin3 pinctrl configuration
>    ARM: STi: DT: Add STiH407 family tsin4 pinctrl configuration
>    ARM: STi: DT: Add STiH407 family tsin5 pinctrl configuration
>    ARM: STi: DT: Add STiH407 family tsout0 pinctrl configuration
>    ARM: STi: DT: Add STiH407 family tsout1 pinctrl configuration
>    ARM: STi: DT: Add STiH407 family mtsin0 pinctrl configuration
>
>   arch/arm/boot/dts/stih407-pinctrl.dtsi | 200 +++++++++++++++++++++++++++++++++
>   1 file changed, 200 insertions(+)
>
Series applied for v4.3.

Thanks,
Maxime