From: Nishanth Menon <nm@ti.com>
To: Keerthy <a0393675@ti.com>,
Nishanth Menon <menon.nishanth@gmail.com>,
Tony Lindgren <tony@atomide.com>
Cc: "H. Nikolaus Schaller" <hns@goldelico.com>,
"Grygorii Strashko" <grygorii.strashko@ti.com>,
"Laxman Dewangan" <ldewangan@nvidia.com>,
"Benoît Cousson" <bcousson@baylibre.com>,
"Rob Herring" <robh+dt@kernel.org>,
"Pawel Moll" <pawel.moll@arm.com>,
"Mark Rutland" <mark.rutland@arm.com>,
"Ian Campbell" <ijc+devicetree@hellion.org.uk>,
"Kumar Gala" <galak@codeaurora.org>,
"Russell King" <linux@arm.linux.org.uk>,
linux-omap <linux-omap@vger.kernel.org>,
devicetree@vger.kernel.org, LKML <linux-kernel@vger.kernel.org>,
"Marek Belisko" <marek@goldelico.com>,
"Gražvydas Ignotas" <notasas@gmail.com>,
Keerthy <j-keerthy@ti.com>
Subject: Re: [PATCH 1/3] ARM: dts: omap5-board-common: enable rtc and charging of backup battery
Date: Thu, 14 Jan 2016 11:39:24 -0600 [thread overview]
Message-ID: <5697DD4C.8010701@ti.com> (raw)
In-Reply-To: <56977211.8070206@ti.com>
On 01/14/2016 04:01 AM, Keerthy wrote:
>
>
> On Thursday 14 January 2016 04:02 AM, Nishanth Menon wrote:
>> On 01/13/2016 01:40 PM, Tony Lindgren wrote:
>>
>>> Anyways, considering what's been discussed, after the minimal RTC fix
>>> we could also add code to allow the TWL driver optionally configure the
>>> GPIO. This way the TWL driver could also check the GPIO state in case
>>> some out-of-our-control mystery software goes tweak the msecure pin
>>> state.
>>
>> I dont even know how that will work:
>> If you are using MSECURE as it is intended to be, then you'd mux it to
>> msecure, which means that GPIO read is just a waste of time - you dont
>> even mux it to external world. Now, some SoCs like DRA7 has input lines
>> always connected. even assuming this is for such a case:
>> a) when you are running linux, you are already in nonsecure - it needs
>> no read of MSECURE GPIO to figure that out.
>> b) when you are in secure world, Linux wont be running either.
>>
>> Reading from GPIO is just misguided in my opinion. firewalls are not
>> reconfigured, and muxes are usually done a single time.
>>
>> Or the RTC driver could just check that the bits really change
>>> after= writing them. Then we would at least know things are not working
>>> right for the TWL related RTC drivers.
>>
>> that is reasonable to check, but just a overhead - anyways, just
>> isolated to palmas-rtc.. fail reason maynot always be issues with
>> MSECURE mux.. it could be very well be 32k clk fail etc.. but yeah -
>> that might give a hint that there is an issue..
>>
>
> IIRC without configuring the mux mode of gpio234 to msecure mode we were
> unable to write to the rtc registers. Hence configured it one time at boot.
>
Looks like you missed the code section that shows that the u-boot
configuration was overridden by kernel as GPIO for the very same reason.!
http://git.omapzoom.org/?p=kernel/omap.git;a=blob;f=arch/arm/mach-omap2/board-omap5panda.c;h=6113bc0e04625a1bd794b3f169581c67ad3b42ff;hb=refs/heads/p-linux-omap-3.4#l816
--
Regards,
Nishanth Menon
next prev parent reply other threads:[~2016-01-14 17:40 UTC|newest]
Thread overview: 52+ messages / expand[flat|nested] mbox.gz Atom feed top
2016-01-05 12:01 [PATCH 0/3] Enable twl603x-GPADC for some OMAP4/OMAP5 boards and Palmas-RTC for OMAP5 H. Nikolaus Schaller
2016-01-05 12:01 ` [PATCH 1/3] ARM: dts: omap5-board-common: enable rtc and charging of backup battery H. Nikolaus Schaller
2016-01-05 23:40 ` Nishanth Menon
2016-01-06 1:00 ` Tony Lindgren
2016-01-06 8:11 ` H. Nikolaus Schaller
2016-01-06 16:41 ` Tony Lindgren
2016-01-06 16:47 ` H. Nikolaus Schaller
2016-01-06 17:09 ` Tony Lindgren
2016-01-08 17:49 ` H. Nikolaus Schaller
2016-01-08 18:15 ` Tony Lindgren
2016-01-08 18:32 ` H. Nikolaus Schaller
2016-01-08 19:04 ` Tony Lindgren
2016-01-08 19:31 ` H. Nikolaus Schaller
2016-01-11 20:24 ` Tony Lindgren
2016-01-12 0:09 ` Tony Lindgren
2016-01-12 13:30 ` H. Nikolaus Schaller
2016-01-12 21:27 ` H. Nikolaus Schaller
2016-01-12 21:37 ` Nishanth Menon
2016-01-12 22:13 ` Tony Lindgren
2016-01-13 10:25 ` H. Nikolaus Schaller
2016-01-13 14:55 ` Nishanth Menon
2016-01-13 15:14 ` Grygorii Strashko
2016-01-13 16:48 ` Tony Lindgren
2016-01-13 17:12 ` Grygorii Strashko
2016-01-13 17:38 ` Nishanth Menon
2016-01-13 18:00 ` H. Nikolaus Schaller
2016-01-13 18:23 ` Nishanth Menon
2016-01-13 17:29 ` Nishanth Menon
2016-01-13 18:00 ` Tony Lindgren
2016-01-13 18:08 ` H. Nikolaus Schaller
2016-01-13 18:31 ` Nishanth Menon
2016-01-13 18:44 ` H. Nikolaus Schaller
2016-01-13 19:05 ` Nishanth Menon
2016-01-13 19:22 ` Grygorii Strashko
2016-01-13 19:40 ` Tony Lindgren
2016-01-13 22:32 ` Nishanth Menon
2016-01-14 10:01 ` Keerthy
2016-01-14 17:39 ` Nishanth Menon [this message]
2016-01-14 18:35 ` Tony Lindgren
2016-01-15 14:33 ` H. Nikolaus Schaller
2016-01-15 15:47 ` Tony Lindgren
2016-01-15 17:10 ` Tony Lindgren
2016-01-15 18:11 ` H. Nikolaus Schaller
2016-08-25 2:43 ` Matthijs van Duin
2016-01-13 18:18 ` Nishanth Menon
2016-01-06 7:42 ` H. Nikolaus Schaller
2016-01-06 8:13 ` Laxman Dewangan
2016-01-06 14:36 ` Nishanth Menon
2016-01-06 19:34 ` Rob Herring
2016-01-06 19:53 ` Nishanth Menon
2016-01-05 12:01 ` [PATCH 2/3] ARM: dts: omap5-board-common: enable iio gpadc for Palmas H. Nikolaus Schaller
2016-01-05 12:01 ` [PATCH 3/3] ARM: dts: twl6030: add gpadc H. Nikolaus Schaller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=5697DD4C.8010701@ti.com \
--to=nm@ti.com \
--cc=a0393675@ti.com \
--cc=bcousson@baylibre.com \
--cc=devicetree@vger.kernel.org \
--cc=galak@codeaurora.org \
--cc=grygorii.strashko@ti.com \
--cc=hns@goldelico.com \
--cc=ijc+devicetree@hellion.org.uk \
--cc=j-keerthy@ti.com \
--cc=ldewangan@nvidia.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=linux@arm.linux.org.uk \
--cc=marek@goldelico.com \
--cc=mark.rutland@arm.com \
--cc=menon.nishanth@gmail.com \
--cc=notasas@gmail.com \
--cc=pawel.moll@arm.com \
--cc=robh+dt@kernel.org \
--cc=tony@atomide.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
Powered by JetHome