Re: [PATCH v3] net: phy: DP83TC811: Introduce support for the DP83TC811 phy

[Dan Murphy <dmurphy@ti.com>]

Andrew

On 05/11/2018 01:30 PM, Andrew Lunn wrote:
> On Fri, May 11, 2018 at 01:08:19PM -0500, Dan Murphy wrote:
>> Add support for the DP83811 phy.
>>
>> The DP83811 supports both rgmii and sgmii interfaces.
>> There are 2 part numbers for this the DP83TC811R does not
>> reliably support the SGMII interface but the DP83TC811S will.
>>
>> There is not a way to differentiate these parts from the
>> hardware or register set.  So this is controlled via the DT
>> to indicate which phy mode is required.  Or the part can be
>> strapped to a certain interface.
>>
>> Data sheet can be found here:
>> http://www.ti.com/product/DP83TC811S-Q1/description
>> http://www.ti.com/product/DP83TC811R-Q1/description
>>
>> Signed-off-by: Dan Murphy <dmurphy@ti.com>
> 
> Hi Dan
> 
> It is normal to add any Reviewed-by, or Tested-by: tags you received,
> so long as you don't make major changes.
> 

Thanks for the reminder.

I usually add them if I get them explicitly stated in the review.

I have not seen any Reviewed-by or Tested-by tags in any of the replies for the
patch.  But I may have missed it.

Dan

>     Andrew
> 


-- 
------------------
Dan Murphy