Re: [PATCH v2 1/2] dt-bindings: mtd: brcmnand: Make nand-ecc-strength and nand-ecc-step-size optional

[Schrempf Frieder <frieder.schrempf@kontron.de>]

Hi Kamal,

On 20.05.19 21:05, Kamal Dasu wrote:
> nand-ecc-strength and nand-ecc-step-size can be made optional as
> brcmnand driver can support using raw NAND layer detected values.
> 
> Signed-off-by: Kamal Dasu <kdasu.kdev@gmail.com>
> ---
>   Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt | 4 ++--
>   1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> index bcda1df..29feaba 100644
> --- a/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> +++ b/Documentation/devicetree/bindings/mtd/brcm,brcmnand.txt
> @@ -101,10 +101,10 @@ Required properties:
>                                 number (e.g., 0, 1, 2, etc.)
>   - #address-cells            : see partition.txt
>   - #size-cells               : see partition.txt
> -- nand-ecc-strength         : see nand.txt
> -- nand-ecc-step-size        : must be 512 or 1024. See nand.txt
>   
>   Optional properties:
> +- nand-ecc-strength         : see nand.txt
> +- nand-ecc-step-size        : must be 512 or 1024. See nand.txt
>   - nand-on-flash-bbt         : boolean, to enable the on-flash BBT for this
>                                 chip-select. See nand.txt
>   - brcm,nand-oob-sector-size : integer, to denote the spare area sector size

I think you also need to change all references to nand.txt. This file 
was recently moved to nand-controller.yaml.

Regards,
Frieder