Re: [PATCH v3 1/6] dt-bindings: PCI: Add binding for qps615

[Krishna Chaitanya Chundru <quic_krichai@quicinc.com>]

On 2/10/2025 1:21 PM, Manivannan Sadhasivam wrote:
> On Wed, Dec 04, 2024 at 02:19:56PM +0530, Krishna Chaitanya Chundru wrote:
> 
> [...]
> 
>>>>> +                pcie@3,0 {
>>>>> +                    reg = <0x21800 0x0 0x0 0x0 0x0>;
>>>>> +                    #address-cells = <3>;
>>>>> +                    #size-cells = <2>;
>>>>> +                    device_type = "pci";
>>>>> +                    ranges;
>>>>> +                    bus-range = <0x05 0xff>;
>>>>> +
>>>>> +                    qcom,tx-amplitude-millivolt = <10>;
>>>>> +                    pcie@0,0 {
>>>>> +                        reg = <0x50000 0x0 0x0 0x0 0x0>;
>>>>> +                        #address-cells = <3>;
>>>>> +                        #size-cells = <2>;
>>>>> +                        device_type = "pci";
>>>>
>>>> There's a 2nd PCI-PCI bridge?
>>> This the embedded ethernet port which is as part of DSP3.
>>>
>> Hi Rob,
>>
>> Can you please check my response on your queries, if you need
>> any extra information, we can provide to sort this out.
>>
> 
> I believe Rob was pointing the 'device_type' property which is not needed for
> PCI device nodes but only for nodes implementing PCI bus (like host bridge, PCI
> bridge).
> 
Got it, I will remove device_type in the next patch series.

- Krishna Chaitanya.
> - Mani
>