On Fri, 17 Dec 2010 10:01:26 +1000, Dave Airlie wrote: > (cc'ing Chris). > > On Fri, Dec 17, 2010 at 8:23 AM, Harald Dunkel wrote: > > -----BEGIN PGP SIGNED MESSAGE----- > > Hash: SHA1 > > > > Hi folks, > > > > according to http://bugs.debian.org/607300 I have to rebuild 2.6.36.2 > > with CONFIG_DRM_I915_KMS=y. Problem: > > > > At boot time I get a message "waiting for /dev to be fully populated", > > then the screen goes blank and the monitor enters power save mode. > > 2.6.36.2 without CONFIG_DRM_I915_KMS didn't show this problem. > > > > My grub2 configuration says > > > >        GRUB_GFXMODE=1280x1024 > >        GRUB_GFXPAYLOAD_LINUX="keep" > > > > If I comment out these 2 lines and rebuild grub.cfg, then the problem > > goes away, too. I just get a 80x25 display for grub in this case. > > > > Is this a regression since 2.6.36 or 2.6.35? Sounds like: commit 47f1c6c9ffdec0c0e5a2c2709bd63c7380b325c4 Author: Chris Wilson Date: Fri Dec 3 15:37:31 2010 +0000 drm/i915: Clean conflicting modesetting registers upon init If we leave the registers in a conflicting state then when we attempt to teardown the active mode, we will not disable the pipes and planes in the correct order -- leaving a plane reading from a disabled pipe and possibly leading to undefined behaviour. Reported-and-tested-by: Andy Whitcroft Bugzilla: https://bugs.freedesktop.org/show_bug.cgi?id=32078 Signed-off-by: Chris Wilson Cc: stable@kernel.org which was prompted by an investigation as to why grub2 was causing a modesetting failure. -Chris -- Chris Wilson, Intel Open Source Technology Centre