Re: [PATCH v3 2/2] led: led-class: Read max-brightness from devicetree

[Jacek Anaszewski <jacek.anaszewski@gmail.com>]

Hi Astrid,

Thanks for the update.

On 7/3/23 15:03, Astrid Rost wrote:
> Normally, the maximum brightness is determined by the hardware, and this
> property is not required. This property is used to set a software limit.
> It could happen that an LED is made so bright that it gets damaged or
> causes damage due to restrictions in a specific system, such as mounting
> conditions.
> Note that this flag is mainly used for PWM-LEDs, where it is not possible
> to map brightness to current. Drivers for other controllers should use
> led-max-microamp.
> 
> Reviewed-by: Andy Shevchenko <andriy.shevchenko@linux.intel.com>
> Signed-off-by: Astrid Rost <astrid.rost@axis.com>
> ---
>   drivers/leds/led-class.c | 4 ++++
>   1 file changed, 4 insertions(+)
> 
> diff --git a/drivers/leds/led-class.c b/drivers/leds/led-class.c
> index 9255bc11f99d..ce652abf9336 100644
> --- a/drivers/leds/led-class.c
> +++ b/drivers/leds/led-class.c
> @@ -457,6 +457,10 @@ int led_classdev_register_ext(struct device *parent,
>   			if (fwnode_property_present(init_data->fwnode,
>   						    "retain-state-shutdown"))
>   				led_cdev->flags |= LED_RETAIN_AT_SHUTDOWN;
> +
> +			fwnode_property_read_u32(init_data->fwnode,
> +				"max-brightness",
> +				&led_cdev->max_brightness);
>   		}
>   	} else {
>   		proposed_name = led_cdev->name;

For the whole set:

Acked-by: Jacek Anaszewski <jacek.anaszewski@gmail.com>

-- 
Best regards,
Jacek Anaszewski