Re: [PATCH 0/8] Add IPROC I2C slave mode and NIC I2C support

[Ray Jui <ray.jui@broadcom.com>]

You sent out the same patch series 3 times without any explanation. Very
confusing.

Is this the latest one that should be reviewed?

Thanks,

Ray

On 1/8/2019 1:16 AM, Rayagonda Kokatanur wrote:
> Hi,
> This patchset contains support for IPROC I2C slave and NIC I2C support.
> Following are the brief changes done inorder to support both IPROC I2C
> slave mode and NIC I2C,
> 
> a. Add support to allow I2C rx transfer upto 255 bytes
> b. Add polling mode support to the iProc I2C driver. Polling mode is used
>    in certain SoCs where interrupt is not connected from the I2C block.
> c. Add warpper read/write access for register to support indirect register
>    access. This is required in certain SoCs with this iProc I2C
>    block registered.
> 
> 
> Ray Jui (1):
>   dt-bindings: i2c: iproc: make 'interrupts' optional
> 
> Rayagonda Kokatanur (5):
>   i2c: iproc: add polling support
>   i2c: iproc: use wrapper for read/write access
>   dt-bindings: i2c: iproc: add "brcm,iproc-nic-i2c" compatible string
>   i2c: iproc: add NIC I2C support
>   arm64: dts: Stingray: Add NIC i2c device node
> 
> Shreesha Rajashekar (2):
>   i2c: iproc: I2C read up to 255 bytes support
>   i2c: iproc: Add Slave mode support
> 
>  .../devicetree/bindings/i2c/brcm,iproc-i2c.txt     |  14 +-
>  .../arm64/boot/dts/broadcom/stingray/stingray.dtsi |  18 +
>  drivers/i2c/busses/Kconfig                         |   1 +
>  drivers/i2c/busses/i2c-bcm-iproc.c                 | 767 +++++++++++++++++----
>  4 files changed, 669 insertions(+), 131 deletions(-)
>