From: Radu Rendec <radu@rendec.net>
To: Eliav Farber <farbere@amazon.com>,
Thomas Gleixner <tglx@kernel.org>,
Talel Shenhar <talel@amazon.com>
Cc: Rob Herring <robh@kernel.org>,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
Conor Dooley <conor+dt@kernel.org>,
devicetree@vger.kernel.org, linux-kernel@vger.kernel.org
Subject: Re: [PATCH v3 4/8] irqchip/al-fic: switch to shared parent interrupt
Date: Wed, 07 Oct 2026 21:06:13 -0400 [thread overview]
Message-ID: <6b831f3d973d078a6836aba07d70ac720b59d52f.camel@rendec.net> (raw)
In-Reply-To: <20261005112458.22291-5-farbere@amazon.com>
On Mon, 2026-10-05 at 11:24 +0000, Eliav Farber wrote:
> Until now the driver requested its parent interrupt using the chained IRQ
> API (irq_set_chained_handler_and_data()), which only works when each
> parent interrupt is wired to a single FIC instance.
>
> A FIC controller is built from groups, each described by its own DT node,
> and the groups of one controller share that controller's output line
> toward the parent. So a real devicetree has several FIC nodes on one
> parent GIC SPI, and a chained handler can only be installed once per
> parent. Cascading compounds this: an aggregating group collects several
> peripherals' outputs onto the line above it.
>
> To support that, request the parent interrupt as a shared interrupt
> (IRQF_SHARED) instead of installing a chained handler. The handler now has
> the standard irqreturn_t prototype and reports whether this instance had
> anything pending, so the shared-IRQ core can tell which instance on the
> line raised the interrupt. IRQF_NO_THREAD is set because the handler only
> demultiplexes to the child domain and must not be forced-threaded; all
> instances sharing a parent line agree on this flag, as the shared-IRQ core
> requires.
>
> The handler reads the group's cause register and returns IRQ_HANDLED when
> any unmasked cause bit is set, IRQ_NONE otherwise. That is the signal the
> shared-IRQ core needs - "did this instance's hardware raise the line" -
> rather than the result of dispatching to the child domain, which for a
> domain sized exactly to the cause register always succeeds.
>
> request_irq() can fail, unlike irq_set_chained_handler_and_data(), so add
> an error path for it. Set IRQ_DOMAIN_FLAG_DESTROY_GC on the domain after
> creating it, so irq_domain_remove() tears the generic chips down too and
> the single call suffices for both the chip-allocation and request_irq()
> failure paths.
>
> Co-developed-by: Talel Shenhar <talel@amazon.com>
> Signed-off-by: Talel Shenhar <talel@amazon.com>
> Signed-off-by: Eliav Farber <farbere@amazon.com>
> ---
> v3:
> - al_fic_irq_handler() no longer derives IRQ_HANDLED/IRQ_NONE from
> generic_handle_domain_irq(), whose return value only reports whether
> the hwirq to virq mapping succeeded - and since the loop iterates
> exactly NR_FIC_IRQS bits, which is the domain's own size, that mapping
> always succeeds. Return IRQ_HANDLED when the masked CAUSE snapshot is
> non-zero instead, which is the correct signal for a shared interrupt.
> - Set IRQ_DOMAIN_FLAG_DESTROY_GC on the domain and let
> irq_domain_remove() free the generic chips, instead of calling
> irq_domain_remove_generic_chips() by hand. Both error paths now go
> through one label. The invalid-free fix from v2 is unaffected; only the
> teardown mechanism changed.
> - Use of_node_full_name() in the request_irq() call.
>
> v2:
> - Fix the request_irq() error path: v1 called irq_free_generic_chip(gc),
> which is kfree(gc) on an interior pointer into the single allocation
> made by irq_domain_alloc_generic_chips() - an invalid free reachable
> when request_irq() fails at probe. Replace it with
> irq_domain_remove_generic_chips() before irq_domain_remove(), and add a
> commit-message paragraph explaining the teardown ordering.
> - Add Co-developed-by/Signed-off-by: Talel Shenhar.
> - Reworded to state the hardware reason for the shared parent (the groups
> of one controller share that controller's output line).
>
> drivers/irqchip/irq-al-fic.c | 28 ++++++++++++++++++----------
> 1 file changed, 18 insertions(+), 10 deletions(-)
>
> diff --git a/drivers/irqchip/irq-al-fic.c b/drivers/irqchip/irq-al-fic.c
> index ee06d0123b7a..4c60da8558ed 100644
> --- a/drivers/irqchip/irq-al-fic.c
> +++ b/drivers/irqchip/irq-al-fic.c
> @@ -4,9 +4,9 @@
> */
>
> #include <linux/bitfield.h>
> +#include <linux/interrupt.h>
> #include <linux/irq.h>
> #include <linux/irqchip.h>
> -#include <linux/irqchip/chained_irq.h>
> #include <linux/irqdomain.h>
> #include <linux/module.h>
> #include <linux/of.h>
> @@ -95,24 +95,21 @@ static int al_fic_irq_set_type(struct irq_data *data, unsigned int flow_type)
> return 0;
> }
>
> -static void al_fic_irq_handler(struct irq_desc *desc)
> +static irqreturn_t al_fic_irq_handler(int irq, void *data)
> {
> - struct al_fic *fic = irq_desc_get_handler_data(desc);
> + struct al_fic *fic = data;
> struct irq_domain *domain = fic->domain;
> - struct irq_chip *irqchip = irq_desc_get_chip(desc);
> struct irq_chip_generic *gc = irq_get_domain_generic_chip(domain, 0);
> unsigned long pending;
> u32 hwirq;
>
> - chained_irq_enter(irqchip, desc);
> -
> pending = readl_relaxed(fic->base + AL_FIC_CAUSE);
> pending &= ~gc->mask_cache;
>
> for_each_set_bit(hwirq, &pending, NR_FIC_IRQS)
> generic_handle_domain_irq(domain, hwirq);
>
> - chained_irq_exit(irqchip, desc);
> + return pending ? IRQ_HANDLED : IRQ_NONE;
> }
>
> static int al_fic_irq_retrigger(struct irq_data *data)
> @@ -140,6 +137,12 @@ static int al_fic_register(struct device_node *node,
> return -ENOMEM;
> }
>
> + /*
> + * Let irq_domain_remove() free the generic chips on either error path
> + * below, instead of calling irq_domain_remove_generic_chips() by hand.
> + */
> + fic->domain->flags |= IRQ_DOMAIN_FLAG_DESTROY_GC;
> +
> ret = irq_alloc_domain_generic_chips(fic->domain,
> NR_FIC_IRQS,
> 1, of_node_full_name(fic->node),
> @@ -162,9 +165,14 @@ static int al_fic_register(struct device_node *node,
> gc->chip_types->chip.flags = IRQCHIP_SKIP_SET_WAKE;
> gc->private = fic;
>
> - irq_set_chained_handler_and_data(fic->parent_irq,
> - al_fic_irq_handler,
> - fic);
> + ret = request_irq(fic->parent_irq, al_fic_irq_handler,
> + IRQF_NO_THREAD | IRQF_SHARED,
> + of_node_full_name(fic->node), fic);
> + if (ret) {
> + pr_err("fail to request irq (%d)\n", ret);
> + goto err_domain_remove;
> + }
> +
> return 0;
>
> err_domain_remove:
Reviewed-by: Radu Rendec <radu@rendec.net>
next prev parent reply other threads:[~2026-10-08 1:06 UTC|newest]
Thread overview: 12+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-10-05 11:24 [PATCH v3 0/8] irqchip/al-fic: shared parent IRQ, error/fatal outputs and affinity Eliav Farber
2026-10-05 11:24 ` [PATCH v3 1/8] irqchip/al-fic: fix argument alignment and a repeated word Eliav Farber
2026-10-05 11:24 ` [PATCH v3 2/8] irqchip/al-fic: use %pOF and raise init log level Eliav Farber
2026-10-05 11:24 ` [PATCH v3 3/8] irqchip/al-fic: keep the device_node instead of a cached name string Eliav Farber
2026-10-08 1:05 ` Radu Rendec
2026-10-05 11:24 ` [PATCH v3 4/8] irqchip/al-fic: switch to shared parent interrupt Eliav Farber
2026-10-08 1:06 ` Radu Rendec [this message]
2026-10-08 8:22 ` Farber, Eliav
2026-10-05 11:24 ` [PATCH v3 5/8] dt-bindings: interrupt-controller: amazon,al-fic: add mask selection Eliav Farber
2026-10-05 11:24 ` [PATCH v3 6/8] irqchip/al-fic: support error and fatal outputs and FIC v2 Eliav Farber
2026-10-05 11:24 ` [PATCH v3 7/8] irqchip/al-fic: add support for FIC v3 Eliav Farber
2026-10-05 11:24 ` [PATCH v3 8/8] irqchip/al-fic: add irq_set_affinity callback Eliav Farber
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=6b831f3d973d078a6836aba07d70ac720b59d52f.camel@rendec.net \
--to=radu@rendec.net \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=farbere@amazon.com \
--cc=krzk+dt@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=robh@kernel.org \
--cc=talel@amazon.com \
--cc=tglx@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®