Re: [PATCH v2 2/2] arm64: dts: qcom: Enable USB controllers for QCS8300

[Krishna Kurapati <quic_kriskura@quicinc.com>]

On 10/26/2024 11:06 PM, Dmitry Baryshkov wrote:
> On Fri, Oct 11, 2024 at 01:16:19PM +0530, Krishna Kurapati wrote:
>> Enable primary USB controller on QCS8300 Ride platform. The primary USB
>> controller is made "peripheral", as this is intended to be connected to
>> a host for debugging use cases.
>>
>> Signed-off-by: Krishna Kurapati <quic_kriskura@quicinc.com>
>> ---
>>   arch/arm64/boot/dts/qcom/qcs8300-ride.dts | 23 +++++++++++++++++++++++
>>   1 file changed, 23 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
>> index 7eed19a694c3..3e925228379c 100644
>> --- a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
>> +++ b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
>> @@ -265,3 +265,26 @@ &ufs_mem_phy {
>>   	vdda-pll-supply = <&vreg_l5a>;
>>   	status = "okay";
>>   };
>> +
>> +&usb_1_hsphy {
>> +	vdda-pll-supply = <&vreg_l7a>;
>> +	vdda18-supply = <&vreg_l7c>;
>> +	vdda33-supply = <&vreg_l9a>;
>> +
>> +	status = "okay";
>> +};
>> +
>> +&usb_qmpphy {
>> +	vdda-phy-supply = <&vreg_l7a>;
>> +	vdda-pll-supply = <&vreg_l5a>;
>> +
>> +	status = "okay";
>> +};
>> +
>> +&usb_1 {
>> +	status = "okay";
>> +};
>> +
>> +&usb_1_dwc3 {
>> +	dr_mode = "peripheral";
>> +};
> 
> So, can it be used as a USB host controller / connector? What needs to
> be done in such a case?
> 
Adding vbus boost pinctrl and changing dr_mode to host must be enough 
for this case.

Regards,
Krishna,