Re: [RFC 6/8] arm: dts: qcom: Add pmic glink support for sm8450-qrd

[Krishna Kurapati PSSNV <quic_kriskura@quicinc.com>]

On 10/27/2023 1:11 AM, Konrad Dybcio wrote:
> 
> 
> On 10/17/23 15:18, Krishna Kurapati wrote:
>> Add Pmic Glink support for sm8450-qrd to facilitate passing
>> of roe switch notifications generated by ADSP to dwc3 core
>> via ucsi and pmic glink's.
>>
>> Signed-off-by: Krishna Kurapati <quic_kriskura@quicinc.com>
>> ---
> No phy+redriver+dp configuration?
> 
Hi Konrad,

  Did you mean adding the following node:

         typec-mux@42 {
                 compatible = "fcs,fsa4480";
                 reg = <0x42>;

                 interrupts-extended = <&tlmm 2 IRQ_TYPE_LEVEL_LOW>;

                 vcc-supply = <&vreg_bob>;
                 mode-switch;
                 orientation-switch;

                 port {
                         fsa4480_sbu_mux: endpoint {
                                 remote-endpoint = <&pmic_glink_sbu>;
                         };
                 };
         };


and then adding port-2 for pmic_glink ?

Usually for role-switch the port-0/1 defined in this patch are 
sufficient. Also if I added it, I don't have a way to currently test it. 
So skipped this node. I will try and see if I can test it and add it if 
possible.

Regards,
Krishna,