[PATCH 11/13] drivers/block/floppy.c: Add function is_ready_state

[Joe Perches <joe@perches.com>]

Used a couple of times, might simplify the code a bit.

Signed-off-by: Joe Perches <joe@perches.com>
---
 drivers/block/floppy.c |   18 ++++++++++++++----
 1 files changed, 14 insertions(+), 4 deletions(-)

diff --git a/drivers/block/floppy.c b/drivers/block/floppy.c
index 4a9cb15..e054fae 100644
--- a/drivers/block/floppy.c
+++ b/drivers/block/floppy.c
@@ -1307,6 +1307,12 @@ static inline int is_selected(int dor, int unit)
 	return ((dor & (0x10 << unit)) && (dor & 3) == unit);
 }
 
+static bool is_ready_state(int status)
+{
+	int state = status & (STATUS_READY | STATUS_DIR | STATUS_DMA);
+	return state == STATUS_READY;
+}
+
 static int set_dor(int fdc, char mask, char data)
 {
 	unsigned char unit;
@@ -1348,8 +1354,10 @@ static void twaddle(void)
 	DRS->select_date = jiffies;
 }
 
-/* reset all driver information about the current fdc. This is needed after
- * a reset, and after a raw command. */
+/*
+ * Reset all driver information about the current fdc.
+ * This is needed after a reset, and after a raw command.
+ */
 static void reset_fdc_info(int mode)
 {
 	int drive;
@@ -1688,7 +1696,7 @@ static int output_byte(char byte)
 	if (status < 0)
 		return -1;
 
-	if ((status & (STATUS_READY | STATUS_DIR | STATUS_DMA)) == STATUS_READY) {
+	if (is_ready_state(status)) {
 		fd_outb(byte, FD_DATA);
 #ifdef FLOPPY_SANITY_CHECK
 		output_log[output_log_pos].data = byte;
@@ -1748,8 +1756,10 @@ static int need_more_output(void)
 
 	if (status < 0)
 		return -1;
-	if ((status & (STATUS_READY | STATUS_DIR | STATUS_DMA)) == STATUS_READY)
+
+	if (is_ready_state(status))
 		return MORE_OUTPUT;
+
 	return result();
 }
 
-- 
1.6.6.rc0.57.gad7a