From: Caleb Cushing <xenoterracide@gmail.com>
To: Jarek Poplawski <jarkao2@gmail.com>
Cc: Frans Pop <elendil@planet.nl>, Andi Kleen <andi@firstfloor.org>,
linux-kernel@vger.kernel.org, netdev@vger.kernel.org
Subject: Re: large packet loss take2 2.6.31.x
Date: Wed, 18 Nov 2009 04:59:03 -0500 [thread overview]
Message-ID: <81bfc67a0911180159g45a45675k44ce3f251c6bddea@mail.gmail.com> (raw)
In-Reply-To: <20091113211640.GA2540@ami.dom.local>
> Might be the same bugzilla report, I guess. We need to establish if
> these pings reach 192.168.1.1, so a short test and tcpdump without any
> special options just to get a few lost cases as seen on both sides.
> (And ifconfigs before and after the test.)
>
> Btw, could you check with lsmod if usbserial module is loaded before
> this test? I'd like to verify this git bisection result. (If the
> module is loaded or you have CONFIG_USB_SERIAL=y instead of m, try to
> recompile the kernel with this option turned off, for this test.)
sorry for taking so long to get back. busy problematic times.
the dumps and ifconfigs are a bit less 'clean' because the router
serves several other computers (none of which have this issue
(windows)) here's the ifconfig -a from the router.
usbserial is not loaded. actually from reading the patch submission I
suspected the official cause might be off... but I'm not kernel
programmer all I know is where I could see the loss during tests.and I
haven't been able to reproduce over dozens of reboots from this
2.6.31.1-test-00091-gfa31221 kernel.
I totally forgot to do it during the dump's so I hope these are still useful
I haven't rebooted this in a few weeks (the router)
br-lan Link encap:Ethernet HWaddr 00:1D:7E:F8:21:66
inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:60613991 errors:0 dropped:0 overruns:0 frame:0
TX packets:67849334 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2172912561 (2.0 GiB) TX bytes:3999263405 (3.7 GiB)
eth0 Link encap:Ethernet HWaddr 00:1D:7E:F8:21:66
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:144116625 errors:0 dropped:0 overruns:0 frame:0
TX packets:122639966 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1986512923 (1.8 GiB) TX bytes:1548485891 (1.4 GiB)
Interrupt:4
eth0.0 Link encap:Ethernet HWaddr 00:1D:7E:F8:21:66
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:57318567 errors:0 dropped:0 overruns:0 frame:0
TX packets:62317675 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3466538358 (3.2 GiB) TX bytes:2132301174 (1.9 GiB)
eth0.1 Link encap:Ethernet HWaddr 00:1D:7E:F8:21:66
inet addr:68.42.198.183 Bcast:255.255.255.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:86777655 errors:0 dropped:0 overruns:0 frame:0
TX packets:60312064 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:205005516 (195.5 MiB) TX bytes:3162930981 (2.9 GiB)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:168 errors:0 dropped:0 overruns:0 frame:0
TX packets:168 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:19706 (19.2 KiB) TX bytes:19706 (19.2 KiB)
wl0 Link encap:Ethernet HWaddr 00:1D:7E:F8:21:68
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:5114480 errors:0 dropped:0 overruns:0 frame:720205
TX packets:7576790 errors:1902 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:762579947 (727.2 MiB) TX bytes:3981402458 (3.7 GiB)
Interrupt:2 Base address:0x5000
this is the ifconfig -a from my desktop while experiencing the issue
eth0 Link encap:Ethernet HWaddr 00:21:9B:06:4C:C9
inet addr:192.168.1.3 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::221:9bff:fe06:4cc9/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3465 errors:0 dropped:0 overruns:0 frame:0
TX packets:4951 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:1467320 (1.3 Mb) TX bytes:631808 (617.0 Kb)
Memory:fdfc0000-fdfe0000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:624 errors:0 dropped:0 overruns:0 frame:0
TX packets:624 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:64397 (62.8 Kb) TX bytes:64397 (62.8 Kb)
--
Caleb Cushing
http://xenoterracide.blogspot.com
next prev parent reply other threads:[~2009-11-18 9:59 UTC|newest]
Thread overview: 42+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-10-31 14:21 Caleb Cushing
2009-10-31 18:44 ` Frans Pop
2009-11-11 20:19 ` Caleb Cushing
2009-11-11 21:47 ` Andi Kleen
2009-11-11 22:05 ` Frans Pop
2009-11-11 22:48 ` Caleb Cushing
2009-11-12 11:38 ` Jarek Poplawski
2009-11-12 13:46 ` Caleb Cushing
2009-11-12 19:04 ` Jarek Poplawski
2009-11-12 21:47 ` Jarek Poplawski
2009-11-13 16:25 ` Caleb Cushing
2009-11-13 17:21 ` Caleb Cushing
2009-11-13 21:16 ` Jarek Poplawski
2009-11-18 9:59 ` Caleb Cushing [this message]
2009-11-18 10:00 ` Caleb Cushing
2009-11-18 13:51 ` Jarek Poplawski
2009-11-18 18:21 ` Caleb Cushing
2009-11-18 20:10 ` Jarek Poplawski
2009-11-18 22:38 ` Jarek Poplawski
2009-11-22 19:35 ` Caleb Cushing
2009-11-22 20:50 ` Jarek Poplawski
2009-11-24 6:17 ` Caleb Cushing
2009-11-24 11:19 ` Jarek Poplawski
2009-11-24 13:46 ` Jarek Poplawski
2009-11-24 15:57 ` [E1000-devel] " Allan, Bruce W
2009-11-24 18:27 ` Jarek Poplawski
2009-11-25 14:06 ` Caleb Cushing
2009-11-25 16:47 ` Caleb Cushing
2009-11-25 19:11 ` Jarek Poplawski
2009-11-27 18:07 ` Caleb Cushing
2009-11-27 21:36 ` Jarek Poplawski
2009-11-27 22:35 ` Caleb Cushing
2009-11-27 22:42 ` Jarek Poplawski
2009-12-04 1:49 ` Caleb Cushing
2009-12-04 9:05 ` Jarek Poplawski
2009-12-04 18:28 ` Caleb Cushing
2009-12-04 20:44 ` Jarek Poplawski
2009-12-04 23:07 ` Caleb Cushing
2009-12-04 23:47 ` Jarek Poplawski
2009-12-05 7:06 ` Caleb Cushing
2009-12-05 7:29 ` Caleb Cushing
2009-12-05 13:57 ` Jarek Poplawski
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=81bfc67a0911180159g45a45675k44ce3f251c6bddea@mail.gmail.com \
--to=xenoterracide@gmail.com \
--cc=andi@firstfloor.org \
--cc=elendil@planet.nl \
--cc=jarkao2@gmail.com \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®