From: Andrew Jeffery <andrew@codeconstruct.com.au>
To: Patrick Williams <patrick@stwcx.xyz>,
Delphine CC Chiu <Delphine_CC_Chiu@wiwynn.com>
Cc: Rob Herring <robh@kernel.org>,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
Conor Dooley <conor+dt@kernel.org>, Joel Stanley <joel@jms.id.au>,
devicetree@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
linux-aspeed@lists.ozlabs.org, linux-kernel@vger.kernel.org
Subject: Re: [PATCH v11 20/27] ARM: dts: aspeed: yosemite4: support medusa board adc sensors
Date: Tue, 30 Jul 2024 13:29:08 +0930 [thread overview]
Message-ID: <86a3b58d00fc475065ad51458504a636e2f67e02.camel@codeconstruct.com.au> (raw)
In-Reply-To: <ZqgTz9DVPcqtTfUC@heinlein.vulture-banana.ts.net>
On Mon, 2024-07-29 at 17:12 -0500, Patrick Williams wrote:
> On Tue, Jul 23, 2024 at 05:23:01PM +0800, Delphine CC Chiu wrote:
> > Add ina233/ina28 support for medusa board adc sensors
> >
> > Signed-off-by: Delphine CC Chiu <Delphine_CC_Chiu@wiwynn.com>
> > ---
> > .../dts/aspeed/aspeed-bmc-facebook-yosemite4.dts | 13 +++++++++++++
> > 1 file changed, 13 insertions(+)
> >
> > diff --git a/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts b/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts
> > index 98eeee49b082..49500db53a13 100644
> > --- a/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts
> > +++ b/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite4.dts
> > @@ -915,6 +915,19 @@ power-sensor@40 {
> > reg = <0x40>;
> > };
> >
> > + power-sensor@41 {
> > + compatible = "ti,ina233";
> > + resistor-calibration = /bits/ 16 <0x0a00>;
> > + current-lsb= /bits/ 16 <0x0001>;
> > + reg = <0x41>;
> > + };
>
> This depends on this unmerged patchset, right?
>
> https://lore.kernel.org/lkml/4a1cb223-448c-3e93-eb38-d86f543659e3@roeck-us.net/
>
> Please resolve the issues Guenter raised.
Probably best to drop these nodes until those issues are resolved and
the binding patch is merged.
Andrew
next prev parent reply other threads:[~2024-07-30 3:59 UTC|newest]
Thread overview: 35+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-07-23 9:22 [PATCH v11 00/27] Add i2c-mux and eeprom devices for Meta Yosemite 4 Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 01/27] ARM: dts: aspeed: yosemite4: Revise i2c-mux devices Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 02/27] ARM: dts: aspeed: yosemite4: Enable adc15 Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 03/27] ARM: dts: aspeed: yosemite4: Enable spi-gpio setting Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 04/27] ARM: dts: aspeed: yosemite4: Enable watchdog2 Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 05/27] ARM: dts: aspeed: yosemite4: Revise quad mode to dual mode Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 06/27] ARM: dts: aspeed: yosemite4: Revise power sensor adm1281 for schematic change Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 07/27] ARM: dts: aspeed: yosemite4: Add gpio pca9506 Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 08/27] ARM: dts: aspeed: yosemite4: Remove space for adm1272 compatible Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 09/27] ARM: dts: aspeed: yosemite4: Enable interrupt setting for pca9555 Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 10/27] ARM: dts: aspeed: yosemite4: Add power sensor for power module reading Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 11/27] ARM: dts: aspeed: yosemite4: Add eeprom for yosemite4 use Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 12/27] ARM: dts: aspeed: yosemite4: Remove temperature sensor for yosemite4 schematic change Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 13/27] ARM: dts: aspeed: yosemite4: Revise adc128d818 adc mode " Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 14/27] ARM: dts: aspeed: yosemite4: Revise ina233 config " Delphine CC Chiu
2024-07-29 22:13 ` Patrick Williams
2024-07-23 9:22 ` [PATCH v11 15/27] ARM: dts: aspeed: yosemite4: Remove idle state setting for yosemite4 NIC connection Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 16/27] ARM: dts: aspeed: yosemite4: Initialize bmc gpio state Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 17/27] ARM: dts: aspeed: yosemite4: Revise mx31790 fan tach config Delphine CC Chiu
2024-07-23 9:22 ` [PATCH v11 18/27] ARM: dts: aspeed: yosemite4: add mctp config for NIC Delphine CC Chiu
2024-07-23 9:23 ` [PATCH v11 19/27] ARM: dts: aspeed: yosemite4: support mux to cpld Delphine CC Chiu
2024-07-23 9:23 ` [PATCH v11 20/27] ARM: dts: aspeed: yosemite4: support medusa board adc sensors Delphine CC Chiu
2024-07-29 22:12 ` Patrick Williams
2024-07-30 3:59 ` Andrew Jeffery [this message]
2024-07-23 9:23 ` [PATCH v11 21/27] ARM: dts: aspeed: yosemite4: support NIC eeprom Delphine CC Chiu
2024-07-23 9:23 ` [PATCH v11 22/27] ARM: dts: aspeed: yosemite4: Revise i2c duty-cycle Delphine CC Chiu
2024-07-29 22:09 ` [PATCH v11 22/27] ARM: dts: aspeed: yosemite4: Revise i2c duty-cycle^[ Patrick Williams
2024-07-23 9:23 ` [PATCH v11 23/27] ARM: dts: aspeed: yosemite4: add fan led config Delphine CC Chiu
2024-07-23 9:23 ` [PATCH v11 24/27] ARM: dts: aspeed: yosemite4: add XDP710 Delphine CC Chiu
2024-07-23 9:23 ` [PATCH v11 25/27] ARM: dts: aspeed: yosemite4: add RTQ6056 support Delphine CC Chiu
2024-07-29 22:03 ` Patrick Williams
2024-07-30 3:56 ` Andrew Jeffery
2024-07-30 6:04 ` Krzysztof Kozlowski
2024-07-23 9:23 ` [PATCH v11 26/27] ARM: dts: aspeed: yosemite4: add MP5990 support Delphine CC Chiu
2024-07-23 9:23 ` [PATCH v11 27/27] ARM: dts: aspeed: yosemite4: Adjust ioexp bus and remove mctp driver Delphine CC Chiu
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=86a3b58d00fc475065ad51458504a636e2f67e02.camel@codeconstruct.com.au \
--to=andrew@codeconstruct.com.au \
--cc=Delphine_CC_Chiu@wiwynn.com \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=joel@jms.id.au \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-aspeed@lists.ozlabs.org \
--cc=linux-kernel@vger.kernel.org \
--cc=patrick@stwcx.xyz \
--cc=robh@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®