Hi, I have a Prism based PCMCIA WLAN card, which I want to use in my workstation PC. I am using a Ricoh RL5c475 based PCMCIA/PCI bridge to attach the card to one of the empty PCI slots. I want to use this PC as a wireless access point (with hostap), but first I want to make sure the card works, so I first want to use the card as a client to an existing wireless access point. So I compiled support into the linux kernel for only the hermes chipset and the yenta driver (no hostap right now). The problem is that when iwconfig is issued, the wireless interface does not show up. I am seeing some error or warning messages in the kernel logs, but I am not sure if they are relevant to this. For example: ... orinoco 0.15 (David Gibson , Pavel Roskin , et al) orinoco_cs 0.15 (David Gibson , Pavel Roskin , et al) pcmcia: request for exclusive IRQ could not be fulfilled. pcmcia: the driver needs updating to supported shared IRQ lines. eth2: failed to initialize firmware (err = -19) orinoco_cs: register_netdev() failed pcmcia: request for exclusive IRQ could not be fulfilled. pcmcia: the driver needs updating to supported shared IRQ lines. eth2: failed to initialize firmware (err = -19) orinoco_cs: register_netdev() failed ... I am also seeing resource allocation errors: PCI: Failed to allocate mem resource #10:2000000@f8000000 for 0000:02:08.0 PCI: Bus 3, cardbus bridge: 0000:02:08.0 IO window: 00009000-000090ff IO window: 00009400-000094ff PREFETCH window: 50000000-51ffffff PCI: Bridge: 0000:00:0e.0 IO window: 9000-afff MEM window: f5000000-f6ffffff PREFETCH window: 50000000-52ffffff I am not sure, but I think the actual error is the (err = -19). I have added some extra printk's into hermes.c. This error originates from the hermes_init function in hermes.c: /* Normally it's a "can't happen" for the command register to be busy when we go to issue a command because we are serializing all commands. However we want to have some chance of resetting the card even if it gets into a stupid state, so we actually wait to see if the command register will unbusy itself here. */ k = CMD_BUSY_TIMEOUT; reg = hermes_read_regn(hw, CMD); while (k && (reg & HERMES_CMD_BUSY)) { if (reg == 0xffff) /* Special case - the card has probably been removed, so don't wait for the timeout */ return -ENODEV; k--; udelay(1); reg = hermes_read_regn(hw, CMD); } reg is indeed 0xffff and the function returns -ENODEV. I need help to further troubleshoot the problem, any directions or hints welcome... Here is the system information: uname -a: Linux bonsai 2.6.19-gentoo-r5 #1 PREEMPT Sun Feb 18 22:04:07 EET 2007 i686 AMD Athlon(tm) 64 Processor 3500+ AuthenticAMD GNU/Linux The grub.conf, /etc/pcmcia/config.opts, lspci, lspcmcia and dmesg output is attached.