Re: [PATCH v2 5/5] usb: xhci: Handle USB transaction error on address command

[Felipe Balbi <felipe.balbi@linux.intel.com>]

[-- Attachment #1: Type: text/plain, Size: 1554 bytes --]


Hi,

Lu Baolu <baolu.lu@linux.intel.com> writes:
> Xhci driver handles USB transaction errors on transfer events,
> but transaction errors are possible on address device command
> completion events as well.
>
> The xHCI specification (section 4.6.5) says: A USB Transaction
> Error Completion Code for an Address Device Command may be due
> to a Stall response from a device. Software should issue a Disable
> Slot Command for the Device Slot then an Enable Slot Command to
> recover from this error.
>
> This patch handles USB transaction errors on address command
> completion events. The related discussion threads can be found
> through below links.
>
> http://marc.info/?l=linux-usb&m=149362010728921&w=2
> http://marc.info/?l=linux-usb&m=149252752825755&w=2
>
> Suggested-by: Mathias Nyman <mathias.nyman@linux.intel.com>
> Signed-off-by: Lu Baolu <baolu.lu@linux.intel.com>
> ---
>  drivers/usb/host/xhci.c | 5 +++++
>  1 file changed, 5 insertions(+)
>
> diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
> index d6b728d..95780f8 100644
> --- a/drivers/usb/host/xhci.c
> +++ b/drivers/usb/host/xhci.c
> @@ -3822,6 +3822,11 @@ static int xhci_setup_device(struct usb_hcd *hcd, struct usb_device *udev,
>  		break;
>  	case COMP_USB_TRANSACTION_ERROR:
>  		dev_warn(&udev->dev, "Device not responding to setup %s.\n", act);
> +
> +		ret = xhci_disable_slot(xhci, udev->slot_id);
> +		if (!ret)
> +			xhci_alloc_dev(hcd, udev);

aren't you leaking previously allocated virt_dev ?

-- 
balbi

[-- Attachment #2: signature.asc --]
[-- Type: application/pgp-signature, Size: 832 bytes --]