Re: [PATCH 3/3] wifi: cfg80211: check if AP has been started before adding new station

[Johannes Berg <johannes@sipsolutions.net>]

On Tue, 2026-09-08 at 11:44 +0200, Slawomir Stepien wrote:
> On wrz 04, 2026 11:25, Johannes Berg wrote:
> > On Thu, 2026-08-13 at 11:04 +0200, Slawomir Stepien wrote:
> > > 
> > >  	case NL80211_IFTYPE_P2P_GO:
> > > +		/* Add a new station only after the AP and link has been started */
> > > +		link_id = wdev->valid_links ? params.link_sta_params.link_id : 0;
> > 
> > max() maybe?
> > 
> > > +		if (!wdev->links[link_id].ap.beacon_interval)
> > > +			return -ENETDOWN;
> > 
> > I think the same issue might exist also for mesh, maybe address that as
> > well?
> > 
> > And I think you could have a fourth patch to clean up the mac80211 code
> > to no longer handle the "STA creation on AP_VLAN" case?
> 
> But is there such case?
> The only part I think is related is the handling code when params.vlan is set. However, this code is
> still OK. I do not see any other code that would be a good candidate for removal/change.
> 
> Am I missing something here?

Don't think you're missing anything, there's just the block handling
param->vlan in add_station, it's dead code now. But why not kill it?

> Also, during this check, I've came to a conclusion that I will reword a bit the commit message for
> PATCH 1/3, since userspace can still add STA to AP_VLAN in one go, using
> attrs[NL80211_ATTR_STA_VLAN] and that's fine, since the wdev would be the base AP interface, so all
> check will happen.

Sure :)

johannes