Re: [PATCH] can: Explain PDU in CAN_ISOTP help text

[Oliver Hartkopp <socketcan@hartkopp.net>]

On 13.10.20 16:13, Geert Uytterhoeven wrote:
> The help text for the CAN_ISOTP config symbol uses the acronym "PDU".
> However, this acronym is not explained here, nor in
> Documentation/networking/can.rst.
> Expand the acronym to make it easier for users to decide if they need to
> enable the CAN_ISOTP option or not.
> 
> Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>

Acked-by: Oliver Hartkopp <socketcan@hartkopp.net>

Yes, when you are so deep into it that PDU becomes a word like dog or 
cat ;-)

Thanks,
Oliver

> ---
>   net/can/Kconfig | 5 +++--
>   1 file changed, 3 insertions(+), 2 deletions(-)
> 
> diff --git a/net/can/Kconfig b/net/can/Kconfig
> index 224e5e0283a986d9..7c9958df91d353c8 100644
> --- a/net/can/Kconfig
> +++ b/net/can/Kconfig
> @@ -62,8 +62,9 @@ config CAN_ISOTP
>   	  communication between CAN nodes via two defined CAN Identifiers.
>   	  As CAN frames can only transport a small amount of data bytes
>   	  (max. 8 bytes for 'classic' CAN and max. 64 bytes for CAN FD) this
> -	  segmentation is needed to transport longer PDUs as needed e.g. for
> -	  vehicle diagnosis (UDS, ISO 14229) or IP-over-CAN traffic.
> +	  segmentation is needed to transport longer Protocol Data Units (PDU)
> +	  as needed e.g. for vehicle diagnosis (UDS, ISO 14229) or IP-over-CAN
> +	  traffic.
>   	  This protocol driver implements data transfers according to
>   	  ISO 15765-2:2016 for 'classic' CAN and CAN FD frame types.
>   	  If you want to perform automotive vehicle diagnostic services (UDS),
>