Hi,

In drivers/net/ethernet/qlogic/netxen/netxen_nic_hdr.h there are the 
following macros:

#define NETXEN_DIMM_NUMRANKS(VAL)               ((VAL >> 15) & 0x3)
#define NETXEN_DIMM_DATAWIDTH(VAL)              ((VAL >> 18) & 0x3)
#define NETXEN_DIMM_NUMBANKS(VAL)               ((VAL >> 21) & 0xf)

The NETXEN_DIMM_NUMRANKS and NETXEN_DIMM_DATAWIDTH macros extract 3 bits 
worth of information from VAL however the mask is 0x3 (just 2 bits) 
rather than 0x7 (3 bits). I don't have the hardware or datasheet for the 
hardware so I can't be sure if this is intentional or just a masking bug 
in one and/or both of these two macros.

I highly suspect the NETXEN_DIMM_DATAWIDTH is incorrect because 8 
different data widths are being checked in the switch statement in 
netxen_sysfs_read_dimm():

        switch (dw) {
         case 0x0:
                 dw = 32;
                 break;
         case 0x1:
                 dw = 33;
                 break;
         case 0x2:
                 dw = 36;
                 break;
         case 0x3:
                 dw = 64;
                 break;
         case 0x4:
                 dw = 72;
                 break;
         case 0x5:
                 dw = 80;
                 break;
         case 0x6:
                 dw = 128;
                 break;
         case 0x7:
                 dw = 144;
                 break;
         default:
                 netdev_err(netdev, "Invalid data-width %x\n", dw);
                 goto out;
         }

Anyhow, I'm unsure about this and I wanted to flag this up as potential 
issue in the driver.

Colin