Re: [PATCH 1/2] net, can, ifi: fix "write buffer full" error

[Marek Vasut <marex@denx.de>]

On 02/06/2018 01:02 PM, Heiko Schocher wrote:
> the driver reads in the ISR first the IRQpending register,
> and clears after that in a write *all* bits in it.
> 
> It could happen that the isr register raise bits between
> this 2 register accesses, which leads in lost bits ...
> 
> In case it clears "TX message sent successfully", the driver
> never sends any Tx data, and buffers to userspace run over.
> 
> Fixed this:
> clear only the bits in the IRQpending register, the
> driver had read.
> 
> Signed-off-by: Heiko Schocher <hs@denx.de>

Reviewed-by: Marek Vasut <marex@denx.de>

> ---
> 
>  drivers/net/can/ifi_canfd/ifi_canfd.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/drivers/net/can/ifi_canfd/ifi_canfd.c b/drivers/net/can/ifi_canfd/ifi_canfd.c
> index 2772d05ff11c..05feb8177936 100644
> --- a/drivers/net/can/ifi_canfd/ifi_canfd.c
> +++ b/drivers/net/can/ifi_canfd/ifi_canfd.c
> @@ -607,7 +607,7 @@ static irqreturn_t ifi_canfd_isr(int irq, void *dev_id)
>  		return IRQ_NONE;
>  
>  	/* Clear all pending interrupts but ErrWarn */
> -	writel(clr_irq_mask, priv->base + IFI_CANFD_INTERRUPT);
> +	writel(isr & clr_irq_mask, priv->base + IFI_CANFD_INTERRUPT);
>  
>  	/* RX IRQ or bus warning, start NAPI */
>  	if (isr & rx_irq_mask) {
> 


-- 
Best regards,
Marek Vasut