Re: [PATCH] arm64: dts: qcom: qcm6490-fairphone-fp5: Add thermistor for UFS/RAM

["Luca Weiss" <luca.weiss@fairphone.com>]

On Sun Oct 6, 2024 at 10:26 PM CEST, Dmitry Baryshkov wrote:
> On Wed, Oct 02, 2024 at 03:01:08PM GMT, Luca Weiss wrote:
> > Configure the ADC and thermal zone for the thermistor next to the
> > UFS+RAM chip which is connected to GPIO_12 of PM7250B. It is used to
> > measure the temperature of that area of the PCB.
> > 
> > Signed-off-by: Luca Weiss <luca.weiss@fairphone.com>
> > ---
> >  arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts | 40 ++++++++++++++++++++++
> >  1 file changed, 40 insertions(+)
> > 
> > diff --git a/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts b/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
> > index 8ab30c01712e0b7c0cc1b403e0fe01650315b9e2..fdc62f1b1c5a398abaa71818fdf2858fdc445d28 100644
> > --- a/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
> > +++ b/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
> > @@ -207,6 +207,20 @@ active-config0 {
> >  			};
> >  		};
> >  
> > +		mem-thermal {
> > +			polling-delay-passive = <0>;
> > +
> > +			thermal-sensors = <&pm7250b_adc_tm 2>;
> > +
> > +			trips {
> > +				active-config0 {
> > +					temperature = <125000>;
> > +					hysteresis = <1000>;
> > +					type = "passive";
>
> Is it really just "passive"? Especially with no cooling devices it
> sounds more like "critical". LGTM otherwise.

Hi Dmitry,

To be clear, I'm adding the thermal zones now as a first step so that
that they are declared and that they show up in /sys.

This is for sure not the complete thermal configuration. Most other
thermal zones in this dts also currently have 125 degC "passive" trip
point, which I'd hope the device would never ever reach.

Regards
Luca

>
> > +				};
> > +			};
> > +		};
> > +
> >  		pm8008-thermal {
> >  			polling-delay-passive = <100>;
> >  			thermal-sensors = <&pm8008>;