On Tue Sep 9, 2025 at 7:53 PM CEST, Marc Kleine-Budde wrote:
> The M_CAN IP core has an Interrupt Register (IR) and an Interrupt
> Enable (IE) register. An interrupt is triggered if at least 1 bit is
> set in the bitwise and of IR and IE.
>
> Depending on the configuration not all interrupts are enabled in the
> IE register. However the m_can_rx_handler() IRQ handler looks at all
> interrupts not just the enabled ones. This may lead to handling of not
> activated interrupts.
>
> Fix the problem and mask the irqstatus (IR register) with the
> active_interrupts (cached value of IE register).
>
> Fixes: e0d1f4816f2a ("can: m_can: add Bosch M_CAN controller support")
> Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>
> ---
>  drivers/net/can/m_can/m_can.c | 3 +++
>  1 file changed, 3 insertions(+)
>
> diff --git a/drivers/net/can/m_can/m_can.c b/drivers/net/can/m_can/m_can.c
> index fe74dbd2c966..16b38e6c3985 100644
> --- a/drivers/net/can/m_can/m_can.c
> +++ b/drivers/net/can/m_can/m_can.c
> @@ -1057,6 +1057,7 @@ static int m_can_poll(struct napi_struct *napi, int quota)
>  	u32 irqstatus;
>  
>  	irqstatus = cdev->irqstatus | m_can_read(cdev, M_CAN_IR);
> +	irqstatus &= cdev->active_interrupts;
>  
>  	work_done = m_can_rx_handler(dev, quota, irqstatus);
>  
> @@ -1243,6 +1244,8 @@ static int m_can_interrupt_handler(struct m_can_classdev *cdev)
>  	}
>  
>  	m_can_coalescing_update(cdev, ir);
> +
> +	ir &= cdev->active_interrupts;

m_can_coalescing_update() can change active_interrupts, meaning the
interrupt that caused the interrupt handler to run may be disabled in
active_interrupts above and then masked in this added line. Would that
still work or does it confuse the hardware?

Best
Markus

>  	if (!ir)
>  		return IRQ_NONE;
>