Re: [PATCH v2 4/7] can: m_can: m_can_chip_config(): bring up interface in correct state

["Markus Schneider-Pargmann" <msp@baylibre.com>]

[-- Attachment #1: Type: text/plain, Size: 1429 bytes --]

On Tue Sep 9, 2025 at 7:53 PM CEST, Marc Kleine-Budde wrote:
> In some SoCs (observed on the STM32MP15) the M_CAN IP core keeps the
> CAN state and CAN error counters over an internal reset cycle. An
> external reset is not always possible, due to the shared reset with
> the other CAN core. This caused the core not always be in Error Active
> state when bringing up the controller.
>
> Instead of always setting the CAN state to Error Active in
> m_can_chip_config(), fix this by reading and decoding the Protocol
> Status Regitser (PSR) and set the CAN state accordingly.
>
> Fixes: e0d1f4816f2a ("can: m_can: add Bosch M_CAN controller support")
> Signed-off-by: Marc Kleine-Budde <mkl@pengutronix.de>

Reviewed-by: Markus Schneider-Pargmann <msp@baylibre.com>

> ---
>  drivers/net/can/m_can/m_can.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/net/can/m_can/m_can.c b/drivers/net/can/m_can/m_can.c
> index 3edf01b098a4..efd9c23edd4a 100644
> --- a/drivers/net/can/m_can/m_can.c
> +++ b/drivers/net/can/m_can/m_can.c
> @@ -1620,7 +1620,7 @@ static int m_can_start(struct net_device *dev)
>  	netdev_queue_set_dql_min_limit(netdev_get_tx_queue(cdev->net, 0),
>  				       cdev->tx_max_coalesced_frames);
>  
> -	cdev->can.state = CAN_STATE_ERROR_ACTIVE;
> +	cdev->can.state = m_can_state_get_by_psr(cdev);
>  
>  	m_can_enable_all_interrupts(cdev);
>  


[-- Attachment #2: signature.asc --]
[-- Type: application/pgp-signature, Size: 289 bytes --]