2.4.20 gets duplex wrong on NIC

[Bill Davidsen <davidsen@tmr.com>]

[-- Attachment #1: Type: TEXT/PLAIN, Size: 388 bytes --]

In spite of modules.conf the system boots with the NIC in half duplex. I 
verified this with the mii-tool, I can set it full with mii-tool and it 
works right (copied a CD image 650MB), and the blade in the switch has 
been set either full or auto without gain. Yes, I tried the e100 driver as 
well.

Info I think shows this attached to prevent munging, let me know if more 
is needed.


[-- Attachment #2: Type: TEXT/PLAIN, Size: 2797 bytes --]

Script started on Tue Dec  3 18:16:21 2002
Common profile 1.9 hacked lastmod 2002-11-14 21:55:45-04
No common directory available
Session time 18:16:21 on 12/03/02
oddball:root> tail -20\b\b\b\b\b\b\b\b^[[Kdmesg | tail -20
EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,67), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
hdc: DMA disabled
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI ISAPNP enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html
eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <saw@saw.sw.com.sg> and others
PCI: Found IRQ 9 for device 00:06.0
PCI: Sharing IRQ 9 with 00:07.2
eth0: Intel Corp. 82557/8/9 [Ethernet Pro 100], 00:90:27:07:F2:9E, IRQ 9.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 713807-002, Physical connectors present: RJ45
  Primary interface chip i82555 PHY #1.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0x24c9f043).
  Receiver lock-up workaround activated.
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)
lp: driver loaded but no devices found
oddball:root> mii-tool 
eth0: no autonegotiation, 10baseT-HD, link ok
oddball:root> ifconfig eth0
eth0      Link encap:Ethernet  HWaddr 00:90:27:07:F2:9E  
          inet addr:192.168.192.242  Bcast:192.168.192.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:253 errors:0 dropped:0 overruns:0 frame:0
          TX packets:29 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100 
          RX bytes:28278 (27.6 Kb)  TX bytes:2192 (2.1 Kb)
          Interrupt:9 Base address:0x4000 

oddball:root> mii-tool -F 10baseT-FD /dev/eth0\b \b\b \b\b \b\b \b\b \b\b \b\b \b\b \b\b \beth0
oddball:root> mii-tool 
eth0: 10 Mbit, full duplex, link ok
oddball:root> cat /etc/modules.conf
# $Id: modules.conf 1.3 2002/11/13 20:37:15 root Exp $

# parallel port
alias parport_lowlevel parport_pc

# network card (e100?)
alias eth0 eepro100
options eth0 full_duplex=1

# try to force load sound
#alias sound-slot-0 ac97

# USB info
alias usb-controller	usb-uhci
oddball:root> lsmod
Module                  Size  Used by    Not tainted
lp                      8544   0  (autoclean)
parport                32928   0  (autoclean) [lp]
apm                    11996   1 
eepro100               20940   1 
mii                     3492   0  [eepro100]
serial                 47712   0  (autoclean)
oddball:root> exit
exit

Script done on Tue Dec  3 18:17:46 2002