From: "Marco Berizzi" <pupilla@hotmail.com>
To: <linux-kernel@vger.kernel.org>
Subject: 3C905 + options=0x8
Date: Fri, 17 Oct 2003 12:19:31 +0200 [thread overview]
Message-ID: <Sea2-DAV51Yzr7Oq4mm00004830@hotmail.com> (raw)
Me again.
This is the dmesg after doing "modprobe 3c59x options=0x8 debug=7"
PCI: Found IRQ 10 for device 00:0f.0
3c59x: Donald Becker and others. www.scyld.com/network/vortex.html
See Documentation/networking/vortex.txt
00:0f.0: 3Com PCI 3c905 Boomerang 100baseTx at 0xe400. Vers LK1.1.18-ac
00:60:97:d8:e5:01, IRQ 10
product code 4848 rev 00.0 date 04-28-97
Internal config register is 102001b, transceivers 0xe040.
64K word-wide RAM 1:1 Rx:Tx split, autoselect/10baseT interface.
00:0f.0: Media override to transceiver type 8 (Autonegotiate).
MII transceiver found at address 24, status 786d.
Enabling bus-master transmits and whole-frame receives.
00:0f.0: scatter/gather enabled. h/w checksums disabled
eth0: Dropping NETIF_F_SG since no checksum feature.
eth0: Filling in the Rx ring.
eth0: Media override to transceiver 8 (Autonegotiate).
eth0: Initial media type Autonegotiate.
vortex_up(): writing 0x18302d8 to InternalConfig
eth0: MII #24 status 786d, link partner capability 0021, info1 0020,
setting half-duplex.
eth0: vortex_up() InternalConfig 018302d8.
eth0: vortex_up() irq 10 media status 8a10.
eth0: Media selection timer tick happened, Autonegotiate.
dev->watchdog_timeo=500
eth0: Media selection timer finished, Autonegotiate.
eth0: Media selection timer tick happened, Autonegotiate.
dev->watchdog_timeo=500
eth0: Media selection timer finished, Autonegotiate.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 0.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 5 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 1.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 3 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 2.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 3.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 4.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 5.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 6.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 5 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 7.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 8.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 9.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 10.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 11.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 12.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 13.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 14.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 15.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 5 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
eth0: Media selection timer tick happened, Autonegotiate.
dev->watchdog_timeo=500
eth0: Media selection timer finished, Autonegotiate.
boomerang_start_xmit()
eth0: Trying to send a packet, Tx index 16.
boomerang_interrupt. status=0xe201
eth0: interrupt, status e201, latency 4 ticks.
eth0: In interrupt loop, status e201.
boomerang_interrupt: wake queue
eth0: exiting interrupt, status e000.
boomerang_start_xmit()
This nic doesn't send/receive any packet. Any idea?
PS: Same thing with linux-2.6.0test7
next reply other threads:[~2003-10-17 10:19 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2003-10-17 10:19 Marco Berizzi [this message]
-- strict thread matches above, loose matches on Subject: below --
2003-10-16 15:25 Marco Berizzi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=Sea2-DAV51Yzr7Oq4mm00004830@hotmail.com \
--to=pupilla@hotmail.com \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®