Re: [PATCH v3 2/3] drm: bridge: add it66121 driver

[Laurent Pinchart <laurent.pinchart@ideasonboard.com>]

Hi Neil,

On Wed, Apr 14, 2021 at 10:08:46AM +0200, Neil Armstrong wrote:
> On 14/04/2021 10:06, Robert Foss wrote:
> > On Wed, 14 Apr 2021 at 08:13, Neil Armstrong <narmstrong@baylibre.com> wrote:
> >> Le 13/04/2021 à 22:21, Robert Foss a écrit :
> >>> Hey Neil & Phong,
> >>>
> >>> Thanks for submitting this series!
> >>>
> >>>> +
> >>>> +static const struct drm_bridge_funcs it66121_bridge_funcs = {
> >>>> +       .attach = it66121_bridge_attach,
> >>>> +       .enable = it66121_bridge_enable,
> >>>> +       .disable = it66121_bridge_disable,
> >>>> +       .mode_set = it66121_bridge_mode_set,
> >>>> +       .mode_valid = it66121_bridge_mode_valid,
> >>>> +       .detect = it66121_bridge_detect,
> >>>> +       .get_edid = it66121_bridge_get_edid,
> >>>> +       .atomic_get_output_bus_fmts = it66121_bridge_atomic_get_output_bus_fmts,
> >>>> +       .atomic_get_input_bus_fmts = it66121_bridge_atomic_get_input_bus_fmts,
> >>>> +};
> >>>
> >>> I would like to see an implementation of HPD, since it is supported by
> >>> the hardware[1] (and required by the documentation). IRQ status bit 0
> >>> seems to be the responsible for notifying us about hot plug detection
> >>> events.
> >>
> >> It's implemented in the IRQ handler with the IT66121_INT_STATUS1_HPD_STATUS event.
> > 
> > I didn't even get that far :)
> > 
> > Either way, the HPD support should be exposed in drm_bridge_funcs
> > (.hpd_enable, .hpd_disable (and possibly .hpd_notify)) and
> > drm_bridge.ops (DRM_BRIDGE_OP_HPD).
> 
> Indeed I forgot these calls in the NO_CONNECTOR implementation...

For new bridges, you should no implement connector creation, only the
DRM_BRIDGE_ATTACH_NO_CONNECTOR case should be supported.

-- 
Regards,

Laurent Pinchart