Re: [PATCH] i3c: dw: Disable IBI IRQ depends on hot-join and SIR enabling

[andy.shevchenko@gmail.com]

Fri, Jan 19, 2024 at 01:45:47PM +0800, Dylan Hung kirjoitti:
> Disable IBI IRQ signal and status only when hot-join and SIR enabling of
> all target devices attached to the bus are disabled.

> Fixes: e389b1d72a62 ("i3c: dw: Add support for in-band interrupts")
> 
> Signed-off-by: Dylan Hung <dylan_hung@aspeedtech.com>

Tag block is not supposed to have blank lines.

...

> @@ -1163,8 +1163,10 @@ static void dw_i3c_master_set_sir_enabled(struct dw_i3c_master *master,
>  		global = reg == 0xffffffff;
>  		reg &= ~BIT(idx);
>  	} else {
> -		global = reg == 0;
> +		bool hj_rejected = !!(readl(master->regs + DEVICE_CTRL) & DEV_CTRL_HOT_JOIN_NACK);

'!!()' is redundant.

> +
>  		reg |= BIT(idx);
> +		global = (reg == 0xffffffff) && hj_rejected;
>  	}

Moreover, you can refactor a bit both branches, like

	bool hj_rejected = true;
	...
	if (...) {
		...
	} else {
		hj_rejected = readl(master->regs + DEVICE_CTRL) & DEV_CTRL_HOT_JOIN_NACK;
		...
	}
	global = (reg == 0xffffffff) && hj_rejected;


-- 
With Best Regards,
Andy Shevchenko