Re: Kernel 5.10-rc1 not mounting NAND flash (Bisected to d7157ff49a5b ("mtd: rawnand: Use the ECC framework user input parsing bits"))

[Christophe Leroy <christophe.leroy@csgroup.eu>]

Hi Miquel,

Le 04/11/2020 à 18:38, Miquel Raynal a écrit :
> Hi Christophe,
> 
> Christophe Leroy <christophe.leroy@csgroup.eu> wrote on Wed, 04 Nov
> 2020 18:33:53 +0100:
> 
>> Hi Miquel,
>>
>> I'm unable to boot 5.10-rc1 on my boards. I get the following error:
>>
>> [    4.125811] nand: device found, Manufacturer ID: 0xad, Chip ID: 0x76
>> [    4.131992] nand: Hynix NAND 64MiB 3,3V 8-bit
>> [    4.136173] nand: 64 MiB, SLC, erase size: 16 KiB, page size: 512, OOB size: 16
>> [    4.143534] ------------[ cut here ]------------
>> [    4.147934] Unsupported ECC algorithm!
>> [    4.152142] WARNING: CPU: 0 PID: 1 at drivers/mtd/nand/raw/nand_base.c:5244 nand_scan_with_ids+0x1260/0x1640
>> ...
>> [    4.332052] ---[ end trace e3a36f62cae4ac56 ]---
>> [    4.336882] gpio-nand: probe of c0000000.nand failed with error -22
>>
>> Bisected to commit d7157ff49a5b ("mtd: rawnand: Use the ECC framework user input parsing bits")
>>
>> My first impression is that with that change, the value set in chip->ecc.algo
>> by gpio_nand_probe() in drivers/mtd/nand/raw/gpio.c gets overwritten in rawnand_dt_init()
>>
>> The following change fixes the problem, though I'm not sure it is the right fix. Can you have a look ?
>>
>> diff --git a/drivers/mtd/nand/raw/nand_base.c b/drivers/mtd/nand/raw/nand_base.c
>> index 1f0d542d5923..aa74797cf2da 100644
>> --- a/drivers/mtd/nand/raw/nand_base.c
>> +++ b/drivers/mtd/nand/raw/nand_base.c
>> @@ -5032,7 +5032,8 @@ static int rawnand_dt_init(struct nand_chip *chip)
>>    		chip->ecc.engine_type = nand->ecc.defaults.engine_type;
>>
>>    	chip->ecc.placement = nand->ecc.user_conf.placement;
>> -	chip->ecc.algo = nand->ecc.user_conf.algo;
>> +	if (chip->ecc.algo == NAND_ECC_ALGO_UNKNOWN)
>> +		chip->ecc.algo = nand->ecc.user_conf.algo;
>>    	chip->ecc.strength = nand->ecc.user_conf.strength;
>>    	chip->ecc.size = nand->ecc.user_conf.step_size;
>>
>> ---
>>
>> Thanks
>> Christophe
> 
> Sorry for introducing this issue, I didn't had the time to send the
> Fixes PR yet but I think this issue has been solved already. Could
> you please try with a recent linux-next?
> 

Sorry, same problem with "Linux version 5.10.0-rc2-next-20201104"

Christophe