Re: [PATCH 6/6] arm64: dts: qcom: Add initial support for Nord Ride Embedded board

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 8/31/26 5:21 AM, Shawn Guo wrote:
> From: Bartosz Golaszewski <bartosz.golaszewski@oss.qualcomm.com>
> 
> Add the initial device tree for the Nord Ride Embedded board, the
> non-SCMI variant of the SA8797P automotive Ride board.

[...]

> +		vreg_l7a_1p2: ldo7 {
> +			regulator-name = "vreg_l7a_1p2";
> +			regulator-min-microvolt = <1200000>;
> +			regulator-max-microvolt = <1200000>;
> +			regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
> +			regulator-always-on;
> +			regulator-boot-on;

You mark _a lot_ of regulators as always- and boot-on - is that
necessary for all of them?

[...]

> +	/* PMIC H - "UPMH" satellite (CD90-73961-1) - SID 0x7, Bus E0 */

leftover?

[...]

> +	/* PMIC I - "UPMI" satellite (CD90-73961-1) - SID 0x8, Bus E0 */

likewise, a couple times

[...]

> +		vreg_s2i_gfx0: smps2 {
> +			regulator-name = "vreg_s2i_gfx0";
> +			regulator-min-microvolt = <300000>;
> +			regulator-max-microvolt = <1200000>;
> +			regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
> +			regulator-allow-set-load;
> +			regulator-allowed-modes = <RPMH_REGULATOR_MODE_LPM
> +						   RPMH_REGULATOR_MODE_HPM>;
> +		};
> +
> +		vreg_s7i_mm: smps7 {
> +			regulator-name = "vreg_s7i_mm";
> +			regulator-min-microvolt = <300000>;
> +			regulator-max-microvolt = <1200000>;
> +			regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
> +			regulator-allow-set-load;
> +			regulator-allowed-modes = <RPMH_REGULATOR_MODE_LPM
> +						   RPMH_REGULATOR_MODE_HPM>;

Are these actually exposed as regulators and not RPMHPDs?

Konrad