Re: [PATCH v8 2/4] i2c: tegra: Add HS mode support

[Jon Hunter <jonathanh@nvidia.com>]

On 18/09/2025 18:12, Akhil R wrote:

...

>> OK, I see now. So we need to program the normal timings first and then
>> we are re-using the variables to then program the HS timings. And
>> because of that we cannot setup the HS timing values in the existing
>> case statement?
>>
>>> So, I am not sure if moving this section to the switch block will add
>>> any benefit. We might end up making it more complicated that it is now.
>>
>> Yes that's true. It was really this else part that caught my eye ...
>>
>>    } else if (t->bus_freq_hz > I2C_MAX_FAST_MODE_PLUS_FREQ) {
>>     	t->bus_freq_hz = I2C_MAX_FAST_MODE_PLUS_FREQ;
>>    }
>>
>> It feels like at least this part should be handled as part of the case
>> statement.
> 
> Yes. That makes sense. If you agree, we can remove the else part because
> we weren't doing this before when HS mode support was not there. It is not
> directly related to the HS mode support as well. We can add this at a later
> point in a separate patch if found required.

Hmmm ... I am not sure because then we could potentially program the 
packet header incorrectly later on. May be that will never happen? 
However, I think it would be better to not make any assumptions here and 
make the code as robust as possible.

Jon

-- 
nvpublic