Re: [PATCH v7 11/12] iio: adc: ad7768-1: add filter type and oversampling ratio attributes

[Andy Shevchenko <andy@kernel.org>]

On Thu, May 08, 2025 at 02:05:26PM -0300, Jonathan Santos wrote:
> Separate filter type and decimation rate from the sampling frequency
> attribute. The new filter type attribute enables sinc3, sinc3+rej60
> and wideband filters, which were previously unavailable.
> 
> Previously, combining decimation and MCLK divider in the sampling
> frequency obscured performance trade-offs. Lower MCLK divider
> settings increase power usage, while lower decimation rates reduce
> precision by decreasing averaging. By creating an oversampling
> attribute, which controls the decimation, users gain finer control
> over performance.
> 
> The addition of those attributes allows a wider range of sampling
> frequencies and more access to the device features. Sampling frequency
> table is updated after every digital filter parameter change.
> 
> Changes in the sampling frequency are not allowed anymore while in
> buffered mode.

...

>  static void ad7768_fill_samp_freq_tbl(struct ad7768_state *st)
>  {
> -	unsigned int i;
> +	unsigned int i, freq_filtered, len = 0;
> +
> +	freq_filtered = DIV_ROUND_CLOSEST(st->mclk_freq, st->oversampling_ratio);
> +	for (i = 0; i < ARRAY_SIZE(ad7768_mclk_div_rates); i++) {

> +		st->samp_freq_avail[len] = DIV_ROUND_CLOSEST(freq_filtered,
> +							     ad7768_mclk_div_rates[i]);

Same comment as per previous patch.

> +		/* Sampling frequency cannot be lower than the minimum of 50 SPS */
> +		if (st->samp_freq_avail[len] >= 50)
> +			len++;

Actually I would rather see the assignment once.

	... samp_freq_avail;

	for (i = 0; i < ARRAY_SIZE(ad7768_mclk_div_rates); i++) {
		/* Sampling frequency cannot be lower than the minimum of 50 SPS */
		samp_freq_avail = DIV_ROUND_CLOSEST(freq_filtered, ad7768_mclk_div_rates[i]);
		if (samp_freq_avail < 50)
			continue;

		st->samp_freq_avail[len++] = samp_freq_avail;
	}

> +	}
> +
> +	st->samp_freq_avail_len = len;
> +}

...

> +	res = DIV_ROUND_CLOSEST(st->mclk_freq, freq * st->oversampling_ratio);
>  
>  	/* Find the closest match for the desired sampling frequency */
> +	for (i = 0; i < ARRAY_SIZE(ad7768_mclk_div_rates); i++) {
> +		diff_new = abs(res - ad7768_mclk_div_rates[i]);
>  		if (diff_new < diff_old) {
>  			diff_old = diff_new;
>  			idx = i;
>  		}
>  	}

Hmm... Wasn't the point to include util_macros.h to replace the above?

-- 
With Best Regards,
Andy Shevchenko