From: Bagas Sanjaya <bagasdotme@gmail.com>
To: Alex Davis <alex47794@gmail.com>,
Linux Kernel Mailing List <linux-kernel@vger.kernel.org>,
Linux Wireless <linux-wireless@vger.kernel.org>,
Linux Regressions <regressions@lists.linux.dev>
Cc: Miri Korenblit <miriam.rachel.korenblit@intel.com>
Subject: Re: Latest kernel firmware update breaks intel wifi card.
Date: Thu, 5 Jun 2025 08:48:50 +0700 [thread overview]
Message-ID: <aED3gmw0xqm_lMRQ@archie.me> (raw)
In-Reply-To: <CADiockAtCnLdN1rWTRuMeyuQisAWRyosG_K64AQSdVr-k7CLug@mail.gmail.com>
[-- Attachment #1: Type: text/plain, Size: 4241 bytes --]
[also Cc: iwlwifi folks]
On Wed, Jun 04, 2025 at 05:20:31PM -0400, Alex Davis wrote:
> I have the following card:
> 2f:00.0 Network controller: Intel Corporation Wi-Fi 7(802.11be)
> AX1775*/AX1790*/BE20*/BE401/BE1750* 2x2 (rev 1a)
> Subsystem: Intel Corporation BE200 320MHz [Gale Peak]
> Flags: bus master, fast devsel, latency 0, IRQ 19, IOMMU group 16
> Memory at aa800000 (64-bit, non-prefetchable) [size=16K]
> Capabilities: [40] Power Management version 3
> Capabilities: [50] MSI: Enable- Count=1/1 Maskable- 64bit+
> Capabilities: [70] Express Endpoint, IntMsgNum 0
> Capabilities: [b0] MSI-X: Enable+ Count=32 Masked-
> Capabilities: [100] Advanced Error Reporting
> Capabilities: [148] Secondary PCI Express
> Capabilities: [158] Physical Layer 16.0 GT/s <?>
> Capabilities: [17c] Lane Margining at the Receiver
> Capabilities: [188] Latency Tolerance Reporting
> Capabilities: [190] L1 PM Substates
> Capabilities: [1a0] Vendor Specific Information: ID=0002 Rev=4 Len=100 <?>
> Capabilities: [2a0] Data Link Feature <?>
> Capabilities: [2ac] Precision Time Measurement
> Capabilities: [2b8] Vendor Specific Information: ID=0003 Rev=1 Len=054 <?>
> Capabilities: [500] Vendor Specific Information: ID=0023 Rev=1 Len=010 <?>
> Kernel driver in use: iwlwifi
>
> With the current firmware, I get the following error in dmesg:
> iwlwifi 0000:2f:00.0: Detected crf-id 0x2001910, cnv-id 0x2001910 wfpm
> id 0x80000000
> iwlwifi 0000:2f:00.0: PCI dev 272b/00f4, rev=0x472, rfid=0x112200
> iwlwifi 0000:2f:00.0: Detected Intel(R) Wi-Fi 7 BE200 320MHz
> iwlwifi 0000:2f:00.0: Direct firmware load for
> iwlwifi-gl-c0-fm-c0-93.ucode failed with error -2
> iwlwifi 0000:2f:00.0: TLV_FW_FSEQ_VERSION: FSEQ Version: 0.182.4.1
> iwlwifi 0000:2f:00.0: loaded firmware version 92.67ce4588.0
> gl-c0-fm-c0-92.ucode op_mode iwlmvm
> iwlwifi 0000:2f:00.0: Detected RF FM, rfid=0x112200
> iwlwifi 0000:2f:00.0: loaded PNVM version 71864399
> iwlwifi 0000:2f:00.0: Microcode SW error detected. Restarting 0x0.
> iwlwifi 0000:2f:00.0: Start IWL Error Log Dump:
> iwlwifi 0000:2f:00.0: Transport status: 0x0000004A, valid: 6
> iwlwifi 0000:2f:00.0: Loaded firmware version: 92.67ce4588.0
> gl-c0-fm-c0-92.ucode
> iwlwifi 0000:2f:00.0: 0x00000071 | NMI_INTERRUPT_UMAC_FATAL
> iwlwifi 0000:2f:00.0: 0x000002F0 | trm_hw_status0
> iwlwifi 0000:2f:00.0: 0x00000000 | trm_hw_status1
> iwlwifi 0000:2f:00.0: 0x002C43D6 | branchlink2
> iwlwifi 0000:2f:00.0: 0x002B89BE | interruptlink1
> iwlwifi 0000:2f:00.0: 0x002B89BE | interruptlink2
> iwlwifi 0000:2f:00.0: 0x00015ADA | data1
> iwlwifi 0000:2f:00.0: 0x00000010 | data2
> iwlwifi 0000:2f:00.0: 0x00000000 | data3
> iwlwifi 0000:2f:00.0: 0x00000000 | beacon time
> iwlwifi 0000:2f:00.0: 0x0001A67A | tsf low
> iwlwifi 0000:2f:00.0: 0x00000000 | tsf hi
> iwlwifi 0000:2f:00.0: 0x00000000 | time gp1
> iwlwifi 0000:2f:00.0: 0x00046F7B | time gp2
> iwlwifi 0000:2f:00.0: 0x00000001 | uCode revision type
> iwlwifi 0000:2f:00.0: 0x0000005C | uCode version major
> iwlwifi 0000:2f:00.0: 0x67CE4588 | uCode version minor
> iwlwifi 0000:2f:00.0: 0x00000472 | hw version
> iwlwifi 0000:2f:00.0: 0x58C80002 | board version
> iwlwifi 0000:2f:00.0: 0x800CFD1B | hcmd
> iwlwifi 0000:2f:00.0: 0x00020000 | isr0
> iwlwifi 0000:2f:00.0: 0x20000000 | isr1
> iwlwifi 0000:2f:00.0: 0x48F00002 | isr2
> iwlwifi 0000:2f:00.0: 0x00C0001C | isr3
> iwlwifi 0000:2f:00.0: 0x02000000 | isr4
> iwlwifi 0000:2f:00.0: 0x00000000 | last cmd Id
> iwlwifi 0000:2f:00.0: 0x00015ADA | wait_event
> iwlwifi 0000:2f:00.0: 0x10000004 | l2p_control
> iwlwifi 0000:2f:00.0: 0x00000000 | l2p_duration
> iwlwifi 0000:2f:00.0: 0x00000000 | l2p_mhvalid
> iwlwifi 0000:2f:00.0: 0x00000000 | l2p_addr_match
> iwlwifi 0000:2f:00.0: 0x0000000B | lmpm_pmg_sel
> iwlwifi 0000:2f:00.0: 0x00000000 | timestamp
> iwlwifi 0000:2f:00.0: 0x00000024 | flow_handler
>
> When I use the file iwlwifi-gl-c0-fm-c0.pnvm from the previous
> version, it works. I'm running kernel 6.12.30 in Slackware current
What firmware versions?
Confused...
--
An old man doll... just what I always wanted! - Clara
[-- Attachment #2: signature.asc --]
[-- Type: application/pgp-signature, Size: 228 bytes --]
next prev parent reply other threads:[~2025-06-05 1:48 UTC|newest]
Thread overview: 3+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-06-04 21:20 Alex Davis
2025-06-05 1:48 ` Bagas Sanjaya [this message]
2025-06-05 14:24 ` Alex Davis
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=aED3gmw0xqm_lMRQ@archie.me \
--to=bagasdotme@gmail.com \
--cc=alex47794@gmail.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-wireless@vger.kernel.org \
--cc=miriam.rachel.korenblit@intel.com \
--cc=regressions@lists.linux.dev \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®