From: Wasim Nazir <wasim.nazir@oss.qualcomm.com>
To: Bjorn Andersson <andersson@kernel.org>
Cc: Ulf Hansson <ulf.hansson@linaro.org>,
Rob Herring <robh@kernel.org>,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
Conor Dooley <conor+dt@kernel.org>,
Konrad Dybcio <konradybcio@kernel.org>,
Richard Cochran <richardcochran@gmail.com>,
kernel@oss.qualcomm.com, linux-mmc@vger.kernel.org,
devicetree@vger.kernel.org, linux-kernel@vger.kernel.org,
linux-arm-msm@vger.kernel.org, netdev@vger.kernel.org,
Viken Dadhaniya <viken.dadhaniya@oss.qualcomm.com>,
Sushrut Shree Trivedi <quic_sushruts@quicinc.com>,
Nirmesh Kumar Singh <quic_nkumarsi@quicinc.com>,
Krishna Kurapati <krishna.kurapati@oss.qualcomm.com>,
Mohd Ayaan Anwar <quic_mohdayaa@quicinc.com>,
Dikshita Agarwal <quic_dikshita@quicinc.com>,
Monish Chunara <quic_mchunara@quicinc.com>,
Vishal Kumar Pal <quic_vispal@quicinc.com>
Subject: Re: [PATCH 3/5] arm64: dts: qcom: lemans-evk: Extend peripheral and subsystem support
Date: Thu, 28 Aug 2025 17:53:20 +0530 [thread overview]
Message-ID: <aLBKOH2nSkiNppwQ@hu-wasimn-hyd.qualcomm.com> (raw)
In-Reply-To: <uvdrqzpqc5vki6sh5f7phktuk47egtmfuw3jjvoakrbyhqxwvt@obao75mbrtti>
On Wed, Aug 27, 2025 at 06:06:04PM -0500, Bjorn Andersson wrote:
> On Tue, Aug 26, 2025 at 11:51:02PM +0530, Wasim Nazir wrote:
> > Enhance the Qualcomm Lemans EVK board file to support essential
> > peripherals and improve overall hardware capabilities, as
> > outlined below:
> > - Enable GPI (Generic Peripheral Interface) DMA-0/1/2 and QUPv3-0/2
> > controllers to facilitate DMA and peripheral communication.
> > - Add support for PCIe-0/1, including required regulators and PHYs,
> > to enable high-speed external device connectivity.
> > - Integrate the TCA9534 I/O expander via I2C to provide 8 additional
> > GPIO lines for extended I/O functionality.
> > - Enable the USB0 controller in device mode to support USB peripheral
> > operations.
> > - Activate remoteproc subsystems for supported DSPs such as Audio DSP,
> > Compute DSP-0/1 and Generic DSP-0/1, along with their corresponding
> > firmware.
> > - Configure nvmem-layout on the I2C EEPROM to store data for Ethernet
> > and other consumers.
> > - Enable the QCA8081 2.5G Ethernet PHY on port-0 and expose the
> > Ethernet MAC address via nvmem for network configuration.
> > It depends on CONFIG_QCA808X_PHY to use QCA8081 PHY.
> > - Add support for the Iris video decoder, including the required
> > firmware, to enable video decoding capabilities.
> > - Enable SD-card slot on SDHC.
>
> I know I asked for you to lump things together in the initial
> contribution to provide as much features as possible in that initial
> patch, but now that is in place and this patch really is a bunch of
> independent logical changes and this commit message reads much more like
> a cover letter...
>
> >
> > Co-developed-by: Viken Dadhaniya <viken.dadhaniya@oss.qualcomm.com>
> > Signed-off-by: Viken Dadhaniya <viken.dadhaniya@oss.qualcomm.com>
> > Co-developed-by: Sushrut Shree Trivedi <quic_sushruts@quicinc.com>
> > Signed-off-by: Sushrut Shree Trivedi <quic_sushruts@quicinc.com>
> > Co-developed-by: Nirmesh Kumar Singh <quic_nkumarsi@quicinc.com>
> > Signed-off-by: Nirmesh Kumar Singh <quic_nkumarsi@quicinc.com>
> > Co-developed-by: Krishna Kurapati <krishna.kurapati@oss.qualcomm.com>
> > Signed-off-by: Krishna Kurapati <krishna.kurapati@oss.qualcomm.com>
> > Co-developed-by: Mohd Ayaan Anwar <quic_mohdayaa@quicinc.com>
> > Signed-off-by: Mohd Ayaan Anwar <quic_mohdayaa@quicinc.com>
> > Co-developed-by: Dikshita Agarwal <quic_dikshita@quicinc.com>
> > Signed-off-by: Dikshita Agarwal <quic_dikshita@quicinc.com>
> > Co-developed-by: Monish Chunara <quic_mchunara@quicinc.com>
> > Signed-off-by: Monish Chunara <quic_mchunara@quicinc.com>
> > Co-developed-by: Vishal Kumar Pal <quic_vispal@quicinc.com>
> > Signed-off-by: Vishal Kumar Pal <quic_vispal@quicinc.com>
> > Signed-off-by: Wasim Nazir <wasim.nazir@oss.qualcomm.com>
>
> And I don't think you all wrote this patch, you probably all wrote
> individual pieces and then one of you created the actual patch?
>
> The important part is that we don't want 9 different patch series
> floating around with unmet dependencies and relying on me to try to
> stitch them together.
>
> But if you could do what you did for patch 2, 4, and 5 for logical
> chunks of this change, that would be excellent (i.e. you collect the
> individual patches, you add your signed-off-by, and you send them all
> together).
Sure Bjorn, I will split it in next version of the same series.
--
Regards,
Wasim
next prev parent reply other threads:[~2025-08-28 12:23 UTC|newest]
Thread overview: 44+ messages / expand[flat|nested] mbox.gz Atom feed top
2025-08-26 18:20 [PATCH 0/5] arm64: dts: qcom: lemans-evk: Extend board support for additional peripherals Wasim Nazir
2025-08-26 18:21 ` [PATCH 1/5] dt-bindings: mmc: sdhci-msm: Document the Lemans compatible Wasim Nazir
2025-08-27 1:19 ` Dmitry Baryshkov
2025-08-28 14:54 ` Monish Chunara
2025-08-26 18:21 ` [PATCH 2/5] arm64: dts: qcom: lemans: Add SDHC controller and SDC pin configuration Wasim Nazir
2025-08-27 1:20 ` Dmitry Baryshkov
2025-08-28 14:57 ` Monish Chunara
2025-09-03 16:12 ` Konrad Dybcio
2025-09-03 16:28 ` Wasim Nazir
2025-09-03 17:16 ` Konrad Dybcio
2025-09-04 13:35 ` Dmitry Baryshkov
2025-09-04 14:34 ` Konrad Dybcio
2025-09-04 15:29 ` Wasim Nazir
2025-09-04 17:32 ` Dmitry Baryshkov
2025-09-05 11:14 ` Konrad Dybcio
2025-09-05 11:45 ` Dmitry Baryshkov
2025-09-05 12:04 ` Konrad Dybcio
2025-09-05 13:44 ` Dmitry Baryshkov
2025-09-06 8:28 ` Konrad Dybcio
2025-09-06 10:35 ` Monish Chunara
2025-09-08 7:03 ` Wasim Nazir
2025-08-26 18:21 ` [PATCH 3/5] arm64: dts: qcom: lemans-evk: Extend peripheral and subsystem support Wasim Nazir
2025-08-27 1:35 ` Dmitry Baryshkov
2025-08-28 6:35 ` Sushrut Shree Trivedi
2025-08-28 11:01 ` Dmitry Baryshkov
2025-08-28 13:08 ` Sushrut Shree Trivedi
2025-08-28 13:30 ` Dmitry Baryshkov
2025-08-29 14:20 ` Monish Chunara
2025-08-29 16:24 ` Dmitry Baryshkov
2025-09-01 7:32 ` Krishna Kurapati PSSNV
2025-09-02 2:34 ` Dmitry Baryshkov
2025-09-02 17:16 ` Dmitry Baryshkov
2025-09-03 9:12 ` Krishna Kurapati PSSNV
2025-08-28 15:05 ` Monish Chunara
2025-09-01 11:32 ` Vikash Garodia
2025-08-27 23:06 ` Bjorn Andersson
2025-08-28 12:23 ` Wasim Nazir [this message]
2025-08-28 6:56 ` Krzysztof Kozlowski
2025-08-28 15:15 ` Wasim Nazir
2025-08-26 18:21 ` [PATCH 4/5] arm64: dts: qcom: lemans: Add gpr node Wasim Nazir
2025-08-26 18:21 ` [PATCH 5/5] arm64: dts: qcom: lemans-evk: Add sound card Wasim Nazir
2025-08-27 23:07 ` Bjorn Andersson
2025-08-28 16:21 ` Mohammad Rafi Shaik
2025-08-26 23:19 ` [PATCH 0/5] arm64: dts: qcom: lemans-evk: Extend board support for additional peripherals Rob Herring (Arm)
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=aLBKOH2nSkiNppwQ@hu-wasimn-hyd.qualcomm.com \
--to=wasim.nazir@oss.qualcomm.com \
--cc=andersson@kernel.org \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=kernel@oss.qualcomm.com \
--cc=konradybcio@kernel.org \
--cc=krishna.kurapati@oss.qualcomm.com \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mmc@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=quic_dikshita@quicinc.com \
--cc=quic_mchunara@quicinc.com \
--cc=quic_mohdayaa@quicinc.com \
--cc=quic_nkumarsi@quicinc.com \
--cc=quic_sushruts@quicinc.com \
--cc=quic_vispal@quicinc.com \
--cc=richardcochran@gmail.com \
--cc=robh@kernel.org \
--cc=ulf.hansson@linaro.org \
--cc=viken.dadhaniya@oss.qualcomm.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®