Re: [PATCH v11 1/3] dt-bindings: iio: adc: add max14001

[Marcelo Schmitt <marcelo.schmitt1@gmail.com>]

...
> 
> > > +  interrupts:
> > > +    minItems: 1
> > > +    items:
> > > +      - description: |
> > > +          Asserts high when ADC readings exceed the upper threshold and low
> > > +          when below the lower threshold. Must be connected to the COUT pin.
> > > +      - description: |
> > > +          Alert output that asserts low during a number of different error
> > > +          conditions. The interrupt source must be attached to FAULT pin.
> 
> These descriptions read wrong to me. They __are__ the COUT and FAULT
> pins, given what David responded to above, not something that can be
> connected to these pins (if they were, they would be represented as
> -gpios rather than interrupts most likely). Unless you mean that these
> pins can have some other use and are only available on the COUT/FAULT
> pins when some register value is set - but even in that case saying
> "must be" doesn't fit since the interrupt property could be used to
> configure the device accordingly.

COUT and FAULT are just two pins on the ADC chip that can be used to generate
interrupts. Would a description like the one below sound better?

  interrupts:
    minItems: 1
    items:
      - description: |
          cout: Comparator output signal that asserts high when ADC readings
          exceed the upper threshold and low when readings fall below the lower
          threshold.
      - description: |
          fault: When fault reporting is enabled, the FAULT pin is asserted low
          whenever one of the monitored fault conditions occurs.

Best regards,
Marcelo