Hi Herve,

On Mon, Oct 27, 2025 at 01:35:59PM +0100, Herve Codina (Schneider Electric) wrote:
> On the Renesas RZ/N1 SoC, GPIOs can generate interruptions. Those
> interruption lines are multiplexed by the GPIO Interrupt Multiplexer in
> order to map 32 * 3 GPIO interrupt lines to 8 GIC interrupt lines.
> 
> The GPIO interrupt multiplexer IP does nothing but select 8 GPIO
> IRQ lines out of the 96 available to wire them to the GIC input lines.
> 
> Signed-off-by: Herve Codina (Schneider Electric) <herve.codina@bootlin.com>

Good news first:

Reviewed-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Tested-by: Wolfram Sang <wsa+renesas@sang-engineering.com>

I can access GPIO LEDs on my board and PHY interrupts also work.

> +	if (parent_args->args[1] < RZN1_IRQMUX_GIC_SPI_BASE ||
> +	    parent_args->args[1] >= RZN1_IRQMUX_GIC_SPI_BASE + RZN1_IRQMUX_NUM_OUTPUTS) {
> +		dev_err(dev, "Invalid GIC interrupt %u\n", parent_args->args[1]);
> +		return -EINVAL;
> +	}

I really like this solution. I think I suggested it before but can't
recall the details. And it is not worth digging it up again. Looks good,
works, perfect.

...

> +static int rzn1_irqmux_probe(struct platform_device *pdev)
> +{
> +	struct device *dev = &pdev->dev;
> +	struct device_node *np = dev->of_node;
> +	u32 __iomem *regs;
> +
> +	regs = devm_platform_ioremap_resource(pdev, 0);
> +	if (IS_ERR(regs))
> +		return PTR_ERR(regs);
> +
> +	return rzn1_irqmux_setup(dev, np, regs);

The only super minor thing is that we could fold rzn1_irqmux_setup()
into probe() according to my taste. But I am also fine as is. Looking
really forward to see this series finally going upstream.

Thanks again for your work on this!

   Wolfram