Re: [PATCH rtw-next v7 2/4] wifi: rtw88: sdio: Track running state and cancel TX worker on stop

["Luka Gejak" <luka.gejak@linux.dev>]

Hi Alastair,

Thanks for the new version. One comment below.

October 31, 2026 at 4:35 AM, "Alastair D'Silva" <alastair@d-silva.org> wrote:

> diff --git a/drivers/net/wireless/realtek/rtw88/sdio.c b/drivers/net/wireless/realtek/rtw88/sdio.c
> index e39284b71837..253467250ee6 100644
> --- a/drivers/net/wireless/realtek/rtw88/sdio.c
> +++ b/drivers/net/wireless/realtek/rtw88/sdio.c

[ ... ]

> @@ -1069,20 +1072,38 @@ static int rtw_sdio_start(struct rtw_dev *rtwdev)

[ ... ]

> +     sdio_release_host(rtwsdio->sdio_func);
> +
> +     queue_delayed_work(rtwsdio->txwq, &rtwsdio->tx_handler_data->work, 0);
>
>       return 0;
>  }

I brought up this rearm on v6, but looking at the callers again I think it
may run a bit too early. rtw_sdio_start() is called from rtw_power_on(),
so the worker can start on whatever is parked before rtw_core_start() is
done with the device:

        rtw_core_start()
          rtw_power_on()
            rtw_hci_start()             <- worker queued here
            rtw_fw_send_general_info()
            rtw_coex_init_hw_config()
          rtw_sec_enable_sec_engine()
          set_bit(RTW_FLAG_RUNNING, rtwdev->flags)

The parked frames got their TX descriptor in rtw_sdio_tx_write() before
the stop, with the macid and sec type of that session. So if I read it
right, after an interface down/up or an idle IPS cycle they can go out for
a station that is gone, and maybe even before rtw_sec_enable_sec_engine()
has run. Resume from WoWLAN looks similar, rtw_wow_stop() starts the
HCI while the WoWLAN firmware is still loaded and rtw_wow_swap_fw()
follows right after.

PCI drops what is left in its rings in rtw_pci_stop(), through
rtw_pci_dma_release(). Maybe doing the same here would be safer, purging
rtwsdio->tx_queue[] with ieee80211_purge_tx_queue() and clearing
tx_queue_stopped[] with a wake of those queues, instead of the rearm.
What do you think?

The stop/start cycling in the cover letter was also run on 7.2.10, where
tx_handler_data->work is still a work_struct and the 8723BS HISR mask is
not there yet, so I guess the board ran a backport. Was this version run
on the board as posted?

Best regards,
Luka Gejak