Re: [PATCH v4 1/2] arm64: dts: qcom: monaco-evk: add lt8713sx bridge with displayport

[Vishnu Saini <vishnu.saini@oss.qualcomm.com>]

On Thu, Mar 19, 2026 at 11:11:20AM +0100, Konrad Dybcio wrote:
> On 3/18/26 8:08 PM, Vishnu Saini wrote:
> > Monaco-evk has LT8713sx which act as DP to 3 DP output
> > converter. Edp PHY from monaco soc is connected to lt8713sx
> > as input and output of lt8713sx is connected to 3 mini DP ports.
> > 
> > Two ports are available in mainboard and one port
> > is available on Mezz board.
> > 
> > lt8713sx is connected to soc over i2c0 and with reset gpio
> > connected to pin6 of ioexpander5.
> > 
> > Enable the edp nodes from monaco and enable lontium lt8713sx
> > bridge node.
> > 
> > Co-developed-by: Prahlad Valluru <vvalluru@qti.qualcomm.com>
> > Signed-off-by: Prahlad Valluru <vvalluru@qti.qualcomm.com>
> > Signed-off-by: Vishnu Saini <vishnu.saini@oss.qualcomm.com>
> > Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>
> > ---
> 
> [...]
> 
> > +			port@0 {
> > +				reg = <0>;
> > +				lt8713sx_dp_in: endpoint {
> 
> nit: it'd be neat to have a \n before the property and the following
> subnodes

sure, will add a blank line between reg property and lt8713sx_dp endpoint subnodes in next revision.
 
> otherwise
> 
> Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>
> 
> Konrad